INFORMATION
5Glossary
ATSC
Acronym that stands for Advanced Television Systems Committee and the name of the digital broadcasting standards.
Aspect Ratio
The width of a TV screen relative to its height. Conventional TVs are 4:3 (in other words, the screen is almost square); widescreen models are 16:9 (the screen is almost twice as wide as its height).
Dolby Digital
The system developed by Dolby Labora- tories to compress digital sound. It offers stereo sound (2ch) or
HDTV (high definition TV)
Ultimate digital format that produces high resolution and high picture quality.
NTSC
Acronym that stands for National Television Systems Committee and the name of the current analog broadcasting standards.
Password
A stored
Region Code
Regions associate discs and players with particular areas of the world. this unit will only play back discs that have compatible region codes. You can find the region code of your unit by looking on the rear panel.
Some discs are compatible with more than one region (or all regions).
SDTV (standard definition TV)
Standard digital format that is similar to the NTSC picture quality.
5Maintenance
Cabinet Cleaning
•Wipe the front panel and other exterior surfaces of the unit with a soft cloth immersed in lukewarm water and wrung dry.
•Never use a solvent or alcohol. Do not spray insecticide liquid near the unit. Such chemicals may cause damage and discoloration to the exposed surfaces.
Panel Cleaning
Wipe the panel with a soft cloth. Before cleaning the panel, disconnect the power cord.
Servicing
Should your unit become inoperative, do not try to correct the problem yourself. There are no user serviceable parts inside. Turn off the unit, unplug the power cord and call our toll free customer support line found on the cover of this manual to locate an authorized service center.
Degaussing
A degaussing circuit in this unit clears up color errors on the TV screen. Color errors occur when there is any excess magnetism close to the unit. This circuit is designed to operate once when the unit is fi rst plugged in. If you see minor color errors on the screen, unplug the unit for approximately 30 minutes. When you plug the unit again, the degaussing circuit will operate to clear errors. Take this step any time the TV screen is accidentally magnetized or when you move the unit.
If the Laser Optical Pickup Unit is Dirty
If the unit still does not perform properly when it is operated, while refer- ring to the relevant sections and to "Troubleshooting Guide" in this owner’s manual, the laser optical pickup unit may be dirty. Consult your dealer
or an Authorized Service Center for inspection and cleaning of the laser optical pickup unit.
Disc Handling
•Handle the discs so that fi ngerprints and dust do not adhere to the surfaces of the discs.
•Always store the disc in its protective case when it is not used.
•To
•Do not use a hard cloth since this will mar the disc.
•Wipe the disc in a straight line from center to edge.
•Never wipe with a circular motion.
• Do not use detergent or abrasive cleaning agents.
IR Signal Check
If the remote control is not working properly, you can use an AM radio or digital camera (including a cellular phone with
•With an AM radio:
Tune the AM radio station to a
radio fl utters, it is receiving the remote control’s infrared signal.
• With a digital camera (including built-in cell phone cameras)
Point a digital camera towards the remote control. Push any button on the remote control and look through the digital camera. If the infrared light appears through the camera, the remote control is working.
40
EN