Magnavox 32MF338B user manual Introduction, Read before operating equipment

Page 3

INTRODUCTION

IMPORTANT SAFETY INSTRUCTIONS

Read before operating equipment

INTRODUCTION

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with a dry cloth.

7.Do not block any of the ventilation openings.

Install in accordance with the manufacturers instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and third grounding prong. The wide blade or third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the

 

manufacturer.

12

Use only with a cart, stand, tripod, bracket, or table

 

specified by the manufacturer, or sold with the appara-

tus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when un- used for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the appara- tus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15.Damage Requiring Service - The appliance should be serviced by qualified service personnel when:

A.The power supply cord or the plug has been damaged;

B.Objects have fallen, or liquid has been spilled into the appliance;

C.The appliance has been exposed to rain

D.The appliance does not appear to operate normally or exhibits a marked change in performance;

E.The appliance has been dropped, or the enclosure dam- aged.

16.Tilt/Stability - All televisions must comply with recommended international global safety standards for tilt and stability properties of its cabinet design.

•Do not compromise these design standards by applying excessive pull force to the front, or top, of the cabinet which could ultimately overturn the product.

•Also, do not endanger yourself, or children, by placing electronic equipment/toys on the top of the cabinet. Such items could unsuspectingly fall from the top of the set and cause product damage and/or personal injury.

17.Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer.

18.Power Lines - An outdoor antenna should be located away from power lines.

19.Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges.

Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, ground- ing of the lead-in wire to an antenna discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure below.

20.Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclo- sure through openings.

21.Battery Usage CAUTION - To prevent battery leakage that may result in bodily injury, property damage, or damage to the unit:

•Install all batteries correctly, with + and - aligned as marked on the unit.

•Do not mix batteries (old and new or carbon and

alkaline, etc.).

•Remove batteries when the unit is not used for a long time.

PREPARATION INITIAL SETTING WATCHING TV OPTIOPTIONAL TTINGSETTING TINGTROUTROUBLESHOOTING INFORMATION

Note to the CATV system installer : This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Example ofAntenna Grounding as per NEC - National Electric Code

GROUND CLAMP

ANTENNA LEAD IN WIRE

 

 

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

 

GROUNDING CONDUCTORS (NEC SECTION 810-21)

 

GROUND CLAMPS

ELECTRIC SERVICE EQUIPMENT

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)

3

EN

A8AF2UH_32MF338 B_EN_v2.indd 3

2008/02/15 14:52:16

Page 2 Page 4
Image 3
Page 2 Page 4
Contents 32MF338B LCD TV For Customer Use NotificationRead before operating equipment IntroductionTo Avoid the Hazards of Electrical Shock and Fire When Carrying this TVFCC Warning RADIO-TV Interference5Supplied Accessories 5Symbols Used in this Manual5Mounting the TV Stand Features ContentsDTV/TV/CATV Back 5Buttons on the Remote Control5Installing the Batteries Battery PrecautionsChannel Volume5Control Panel 5Rear PanelConnection to Cable Receiver Box or Satellite Box Preparation5Basic Connection Antenna Connection5External Device Connection Hdmi ConnectionHDMI-DVI Connection Video Connection Component Video ConnectionAudio Output Connection Video in ConnectionFollowing signals can be displayed PC ConnectionFormat Make sure if the TV is connected to antenna or cables Initial Setting5Initial Setup Before you beginAutoprogram 5Main MenuPress Menu to exit 5Language Selection5Channel Selection 5Volume AdjustmentTo Cancel the Sleep Timer Watching TV5Still Mode 5Switching Each Input Mode5Switching Audio Mode 5Screen Information Broadcasting InformationPress Info 5TV Screen Display Mode For 169 video signalFor 43 video signal Use Cursor K/L to select Channel List, then press OK Optional Setting5Channel List 5Add Channels Channel registration listUse Cursor K/L to select Antenna, then press OK 5Antenna ConfirmationSmart Picture 5Picture AdjustmentAdjust the picture quality Use Cursor s/B to adjustTreble, Bass 5Sound AdjustmentReset Sound Settings You can adjust treble and bassCC-3 and T-3 Caption Mode5Closed Caption CC-1 and T-15DTV Closed Caption DTV CCUse Cursor K/L to select DTV CC, then press OK 5CC Style Font StyleFont Size Back Color Font ColorEdge Type Font OpacityUse Cursor K/L to select Parental Control, then press OK 5Parental ControlThen press OK Press OK To Set the Sub RatingsAssociation of America Use Cursor K/L to select US Movie ratings lockTV-Y Use Cursor K/L to select Change Pin, then pressHorizontal Position, Vertical Position 5PC SettingsClock, Phase Auto AdjustmentUse Cursor K/L to select HDMI1 Audio Source, then press OK 5HDMI AudioTroubleshooting 5Troubleshooting GuideAll connections once before calling for service CH. / . Refer to Switching Each Input Mode on Check the batteries of the remote controlRefer to IR Signal Check on May interrupt the remote control signal of this TVWith an AM radio MaintenanceInformation Glossary5Specifications This Limited Warranty does not cover Warranty CoverageWhat is Covered What is not Covered Exclusions Limitations
Top Page Image Contents