Watch the Channel, Six Feet | Magnavox TS 2775 instruction

our TV remote can be set to work your VCR or Cable

Converter by what is called the SEARCH method.

If the "REMOTE CODE" number method shown in the previous section did not set your remote to work your VCR or Converter, then follow the easy steps listed below.

Please read through steps 1-4 before beginning.

<_	Press the POWER	button on
	the VCR or Converter to turn the
	unit ON.
<_	Stand at least six feet away
	from the front of the VCR or
	Converter.
	Point the remote toward the unit.
	HOLD DOWN the SURF and
	the desired System (VCR or
	CBL-Converter) buttons at the
	same time. KEEP HOLDING
	BU'I_FONS DOWN.
<_	Watch the Channel	Indicator
	on the unit.
	Channel Numbers will SCAN UP
	when the unit has been identified.
	This may take up to two minutes.
<_	Release the SURF and System
	(VCR or CBL) buttons as soon
	as channel numbers start to scan

up. The code has been identified and the remote is ready to operate with the VCR or Converter.

Rl._lll_3IllbOl, _. lllllllJt_ (9I

I two can seem very long, but the code should be located within

two minutes.

Don't let the VCR scan up more than five channels. If you do the

remote may pass up the right code and another two minute search

cycle will have to be repeated.

If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work with the desired unit.

CABLE CONVERTER

11!IIIIll

let the VCR or Converter	T
	Six Feet
	(minimum)