Installation and Operation, cont’d
Output Configuration
The following flowchart provides an overview of the Output Configuration submenus and the options for each setting.
Default
Cycle
MENU
PICTURE CONTROL
MENU
OUTPUT CONFIG
NEXT | 1024 x | NEXT | H SYNC V | NEXT |
| H FORMAT | NEXT | |
768 @60 | NEG | POS |
| <H> HV | ||||
|
|
|
|
| ||||
Scaler output rates |
| Sync polarity combinations | Select sync output format |
| ||||
• | See the scaler output table in this | • | • | H+/V- | • | H (default) – specify horizontal sync | ||
| chapter for available combinations of | • | • | H+/V+ | • | HV – specify composite sync |
| |
| resolutions and refresh rates. |
|
|
|
|
|
|
|
Default: 1024 x 768 @60 Hz
NEXT
Resolution and refresh rates
Rotate the horizontal Adjust (
) knob while in this submenu to select one of the available combinations of output resolution rates.
Rotate the vertical Adjust (
) knob while in this submenu to select one of the available refresh (vertical scanning) rates.
Scaler Output Resolutions and Rates
Resolution | 50 Hz | 60 Hz |
|
640 x 480 | X | X |
|
800 x 600 | X | X |
|
848 x 480 | X | X |
|
852 x 480 | X | X |
|
1024 x 768 | X | X* |
|
1280 x 768 | X | X |
|
1360 x 765 | X | X |
|
1366 x 768 | X | X |
|
*The default resolution and rate is 1024 x 768 @ 60Hz.
Sync polarity
The display or projector may require a particular combination of horizontal (H) and vertical (V) sync signal polarities. Select the appropriate combination of positive or negative H and V sync by rotating either the horizontal Adjust (
) or vertical Adjust (
) knob.
H format
To output composite sync, select “HV” as the H Format. Select “H” to output horizontal sync.
Select either H or HV by rotating either the horizontal Adjust (
) or vertical Adjust (
) knob. The default is “H”.