Emotiva Detailed LPA-1 Specifications for Optimal Audio Performance

Page 24

LPA-1 Technical Specifications

Rated Power Output:

Channels 1-5

Channels 6-7

Frequency Response:

20-20Khz:

10-100Khz:

Total Harmonic Distortion (THD):

Channels 1-5:

Channels 6-7:

Signal-to-Noise Ratio:

DC Offset:

Crosstalk:

Damping Factor:

Input Sensitivity Range (Gain):

Channels 1-5

Channels 6-7

Input Impedance (RCA Input)

External Trigger Input:

Clearance for ventilation (Back): Electrical Power Requirement: Electrical Power Consumption:

Raw Weight:

Shipping Weight:

Dimensions:

(All Channels Driven @ 1Khz, 120VAC/ 60HZ supply, THD noted)

125 Watts into 8 Ohms (0.04%THD)

225 Watts into 4 Ohms (0.04%THD)

50 Watts into 8 Ohms (0.05%THD)

95 Watts into 4 Ohms (0.05%THD)

+/-0.1dB

+/-1.0dB

(80kHz measurement bandwidth) <0.040% <0.052%

>100dB, Unweighted (Full Output Reference) <1mV

>75dB

Approximately 200 into 8 Ohms

29dB

26dB

47K Ohm

3-12 VDC, center tip of 3.5mm jack is positive

Minimum 2” / 50 mm

1200 watts @ 115VAC when driven into 8 Ohms

4 Watts (Standby) and 46 Watts (Idle)

63lbs / 28.63kg 70bs / 31.81kg

17” W x 7.75” H x 19” D

432mm W x 197mm H x 483mm D

Page 24

Image 24

Contents USER’S Guide Table of Contents LPA-1 Technical Specifications Limited Warranty Safety Precautions AV123 NEC National Electrical Code Standards Antenna Grounding Outside the HouseThank You for your LPA-1 Purchase Unpacking the LPA-1 InventoryRecording the Serial Number Emotiva LPA-1 Seven Channel Amplifier Front Panel LayoutRear Panel Layout Channels 6 and 7 BridgedInstallation and Connections AC Power ConsiderationsPhysical Placement Input Connection Considerations Output Connection ConsiderationsConnection Tips for Superior Sound Bridging Channels 6Connection Diagrams Connecting a 7.1 Preamp/ProcessorConnection using a 7 channel preout to LPA-1 Connecting a 5.1 Preamp/Processor Connecting a 5.1 and Second Zone System Connection 5 main channels plus a second 2 channel zoneConnecting Multiple Zones Connection of up to 3 distinct 2 channel zonesConnecting an Expanded Second Zone System 12V Trigger Connections Series and Parallel Speaker Connections SeriesParallel Technical Note about Multiple Speaker Connections Troubleshooting Guide No Sound from one or more speakers connected to the LPA-1Turn-on and turn-off thumps Hum Noises in the SpeakersProblems with the whole A/V System Other Probable Causes of NoiseOne or more RED lights on the Front Panel are Blinking LPA-1 Technical Specifications Limited Warranty Service Assistance for the LPA-1AV123 Contact Information Emotiva DisclosureAV123