Scissor Lift by Draper
page 6 of 6
Adjusting Show Position (Up to Standard Position)
➀Find the empty slot in the bottom of the top pan of lift (the only empty slot).
➁ Use the
➂ Find the threaded coupling (long nut) just inside the top pan (through the slot).
➃ Push wrench toward rear of unit to lower.
➄ Pull wrench toward front of unit to raise.
Decrease Show Position
(Stops Higher)
Front
Increase Show Position (Stops Lower)
Rear
Front of Unit
Show Position Adjustments
Adjusting Scissor Lift “Show Position” Past Standard Position (18")
➀If the desired show position is beyond the standard
position (18”) but not more than half the service position, proceed to step #7.
➁If the desired show position is over half the
service position, proceed with the following steps.
➂Remove the top pan cover of the scissor lift.
➃Locate micro switches # 1 and #2 that are wired in series on the micro switch assembly (see figure #1).
➄Disconnect the yellow wire from m/s #1 from the red wire from m/s #2. Disconnect the black wire from m/s #1 from the green wire.
➅Connect the green wire to the red wire from m/s #2 (see figure #2).
➆ At this point you can adjust the micro switch assembly, with
the supplied wrench, through the slot in the bottom of the top pan (see above drawing).
➇ After you have reached the desired show position, raise and lower the unit several times in order to verify show position.
Micro | NC | Micro | NC |
|
| ||
Switch |
| Switch |
|
#2 |
| #1 |
|
COM |
| COM |
|
|
| Jumper |
|
www.draperinc.com 
(765)