Dynex DX-LCD32-09 manual Can I get more information about this TV?, I have sound but no picture

•If you are using an antenna:

oPress MENU. The on-screen menu opens.

oPress < or > to select Channel, then press v to access the Channel menu. o Press ^ or v to select Air/Cable, then press < or > to select Air.

o Press ^ or v to select Auto Scan. Press > or ENTER.

o Press ^ or v to select Start to Scan, then press > or ENTER to start scanning. Your TV memorizes all analog and digital channels you receive.

Can I get more information about this TV?

oRefer to manual that came with your TV or the Dynex Website: dynexproducts.com/pc-680-23-dynex-32-720p-flat-panel-lcd-hdtv-matte-black.aspx

I have sound but no picture.

oMake sure the cables are connected correctly and securely to the jacks on the TV. o The video cable(s) you are using may be bad, try a new set.

o If you are using an antenna, the signal strength of the channel may be low.

ƒCheck the signal strength of the channel by pressing the Display button on the remote. The signal strength is displayed in the lower right corner of the Display screen.

•If the signal level is Weak:

oMake sure your antenna is connected securely to the TV. o Move the antenna around the room or close to a window.

o Use a basic indoor set-top antenna designed to pick up both VHF and UHF.

OR

Use a set-top antenna that has a built-in signal amplifier.

OR

Use an antenna mounted on your roof or in your attic.

o For more information about antennas and the available channels in your area, visit www.antennaweb.org

ƒThe UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower. Getting good UHF reception can be more difficult than VHF.

ƒIf you're getting marginal reception of digital signals, both the picture and sound might freeze or break up to the point that it's not watchable. If you're really on the fringes—either too far from a tower or with too many obstacles in the way—you'll see a black screen that says "No signal."

ƒReception can vary by channel, depending on the location and broadcast power level of a given station.

oIf this troubleshooting does not work, please contact In-Home Service at 1-888-BEST BUY (1-888-237-8289).

I have poor picture quality.

oMake sure your cable connections are connected securely.

oIf you are receiving service from a cable or satellite provider, reception can vary by channel depending on the

broadcast power level of a given station. Contact your cable or satellite provider.

oIf you are using an antenna, the signal strength of the channel may be low.

ƒCheck the signal strength of the channel by pressing the Display button on the remote. The signal strength is displayed in the lower right corner of the Display screen.

•If the signal level is Weak:

oMake sure your antenna is connected securely to the TV. o Move the antenna around the room or close to a window.

o Use a basic indoor set-top antenna designed to pick up both VHF and UHF.

OR

Use a set-top antenna that has a built-in signal amplifier.

OR

Use an antenna mounted on your roof or in your attic.

o For more information about antennas and the available channels in your area, visit www.antennaweb.org

ƒThe UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower. Getting good UHF reception can be more difficult than VHF.

6