Dynex DX-LCD32-09 manual I am receiving the error message “No Signal.”

I am having issues with the picture on my TV (e.g., stripe on the screen, blue lines/dots, red line, etc.).

oMake sure your cables are connected correctly and securely to the jacks on the TV. o The cables you are using may be bad, try a new set.

o If you are using an antenna, the signal strength of the channel may be low.

ƒCheck the signal strength of the channel by pressing the Display button on the remote. The signal strength is displayed in the lower right corner of the Display screen.

•If the signal is Weak:

oMake sure your antenna is connected securely to the TV. o Move the antenna around the room or close to a window.

o Use a basic indoor set-top antenna designed to pick up both VHF and UHF.

OR

Use a set-top antenna that has a built-in signal amplifier.

OR

Use an antenna mounted on your roof or in your attic.

o For more information about antennas and the available channels in your area, visit www.antennaweb.org

ƒThe UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower. Getting good UHF reception can be more difficult than VHF.

ƒIf you're getting marginal reception of digital signals, both the picture and sound might freeze or break up to the point that it's not watchable. If you're really on the fringes—either too far from a tower or with too many obstacles in the way—you'll see a black screen that says "No signal."

ƒReception can vary by channel, depending on the location and broadcast power level of a given station.

oOther devices (e.g., surround sound receiver, external speakers, fans, etc) may be interfering with your TV. Try turning one device off at a time to determine which device is causing the interference.

ƒOnce you have determined which device is causing interference, please move it further from the TV to eliminate the interference.

I am receiving the error message “No Signal.”

oMake sure that your cable is properly plugged into your TV and the source device.

oPress INPUT and make sure have selected the correct input for the device or service you are trying to use. o Are you using a cable/satellite box, cable connected directly to the TV, or an antenna?

ƒIf you are using a cable or satellite box you must use the remote that came with that box to change channels.

•Make sure you have the correct input selected to view channels via the cable or satellite box. For example, if the cable or satellite box is connected via component cables please press input and select Component 1 or Component 2 to view your channels.

ƒIf you are using cable connected directly to the TV, you need to run an autochannel search.

•To run an autochannel search

oPress MENU. The on-screen menu opens.

oPress < or > to select Channel, then press v to access the Channel menu.

oPress ^ or v to select Air/Cable, then press < or > to select Cable.

oPress ^ or v to select Auto Scan. Press > or ENTER.

oPress ^ or v to select Cable System, then press < or > to select your type of cable or satellite system. You can select STD, IRC, HRC, or AUTO. If you are not sure what type of system you have, select AUTO.

oPress ^ or v to select Start to Scan, then press > or ENTER to start scanning. Your TV memorizes all cable channels you receive.

ƒIf you are using an antenna, you need to run an autochannel search.

•To run an autochannel search:

oPress MENU. The on-screen menu opens.

oPress < or > to select Channel, then press v to access the Channel menu. o Press ^ or v to select Air/Cable, then press < or > to select Air.

o Press ^ or v to select Auto Scan. Press > or ENTER.

o Press ^ or v to select Start to Scan, then press > or ENTER to start scanning. Your TV memorizes all analog and digital channels you receive.

2