Fujitsu PDS4212W-H, PDS4211W-H user manual Putting Batteries in the Remote Control

PART NAMES AND FUNCTIONS (Continued)

Remote Control

Strap hole

The remote control comes with a strap. This strap can be attached to the hole provided at the bottom of the remote contorl. (When you attach the strap, remove the battery cover.)

Power ON button [POWER ON]	➝ (See P. E-16.)
Turns the power ON.
Power OFF button [POWER OFF]	➝ (See P. E-16.)
Turns the power OFF.
RGB input mode selector button [RGB]	➝ (See P. E-17.)
Switches between RGB input modes.
Video input mode selector button [VIDEO]	➝ (See P. E-17.)
Switches between video input modes.
Wide screen selector button [WIDE]	➝ (See P. E-18–E-19.)
Switches the screen over to a desired wide screen.
Menu button [MENU]	➝ (See P. E-20–E-39.)

Use this button to display a desired menu for adjusting the image and sound.

Volume adjustment buttons [VOL +/-]	➝ (See P. E-16.)
Adjust the volume.
Press the + button to increase the volume.
Press the - button to reduce the volume.
Adjustment buttons [ / / / ]	➝ (See P. E-20–E-39.)

Use these buttons to scroll through options in a menu and change values.

Enter button [ENTER] ➝ (See P. E-20–E-39.)

Press this button to finalize the selection of a desired menu or option within a menu.

Display selector buttons [SHIFT 1–4] ➝ (See P. E-35–E-39.)

When you use two or more displays, you can use these buttons to control up to four displays by assigning a unique number to each of the displays.

PUTTING BATTERIES IN THE REMOTE CONTROL

1 To remove the cover, slide it	2 Put two AA batteries in the remote	3 Close the cover until it snaps into
outwards while pressing it down.	control. Make sure that the batteries	place.
	are properly oriented.

Note

The remote control will not function properly if the batteries are dead. Be sure to replace them as needed.

Make sure that you use replace the batteries with new ones; also, be sure to use replacement batteries of the same type as the original ones.

E-12