Stewart Filmscreen Corp B installation instructions Factory Advisory, Unpacking

Page 6

Factory Advisory

The factory advises against installing a concealed or recessed electrical projection screen permanently. You must be able to access and remove the unit should future service be necessary.

Suggested solutions for removing the unit include:

KA removable ceiling cover plate under the mounting location.

KAccess to the unit through an attic or overhead space.

Unpacking

Warning!

Failure to remove the batten lock-down screws can result in permanent damage to the screen.

1.DO NOT remove the paper hanging from the trapdoor at this time. You should remove it only after the unit is hung, all electrical connections have been made, and the screen is in operation.

2.Remove the batten lock-down screws located on the back side of the case.

4

Stewart Filmscreen Corporation

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Model B & Model C Electriscreens Stewart Filmscreen Corporation Contents To the Owner About your Model B/Model C Series ElectriscreenPreparing the Installation PreparationFactory Advisory UnpackingInstalling the unit Hanging the CaseElectrical HOOK-UP Installing the low-voltage 3-button switch standard Preparing the connectionMaking the connection Operating the Screen First time operationAdjusting the Screen Extension Underside viewModifying the extension of the screen Screen Care and Cleaning General maintenanceReplacement parts and service Troubleshooting Problem description Probable cause Action to takeMaintenance Notes Fax 310
Top Page Image Contents