3Installation
To install batteries in the remote control:
1.Press down the tab on the cover and pull the cover in the direction of the arrow.
2.Insert the included batteries. Ensure that the polarities correctly match the 
and 
markings inside the battery compartment.
3.Insert the lower tab of the cover into the opening, and press down the cover until it clicks in place.
3.1
Remote Control
• When installing batteries, make sure that the battery polarities are correct. | Notes on Batteries |
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
The remote control can be used to control the PlasmaView within the ranges shown in Figure | Notes on Remote Control |
Operation |
Component SD NTSC | 480i | |
16:9 | V85 | |
|
|
|
|
|
|
|
|
|
Approx.
7m/23ft
LIGHT
OFFON
|
|
|
|
|
| ENT | |||||
RETURN |
|
|
|
|
|
|
| MENU | |||
EXIT |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| MEMORY | ||||||
|
|
| SOURCE SELECTION | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 3-1. Available Range of the Remote Control
Vidikron PlasmaView Owner’s Operating Manual | 13 |