Operation
•You have multiple VHD Controllers and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific device.
Use the VHD Controller
Tip | change the code sent by the remote to match as described below. |
|
Do not change the “Type” setting in this menu.
Note
When you change a remote code on the VHD Controller, you must
1.Using a straightened paper clip or similar object, press and hold the CODE button on the remote control for approximately three seconds, or until the LED on the remote lights solid red.
– OR –
CODE
NT
If your remote control unit does not have a CODE button, press and hold the LIGHT button on the remote control for approximately three seconds, or until the LED on the remote lights solid red.
2. Enter a new
3.The LED turns off to confirm the code change. If you enter an invalid code, the LED flashes for three or four seconds. Try again, entering a valid code.
Display Device: The options in the Display Device menu allow you to perform certain adjustments at the plasma display.
•Display Position: Select Display Position from the Display Device menu to perform the following display device adjustments (these are global, independent of any input):
•Select Left/Right or Up/Down and use the or buttons to
•Select Width or Height and use the or buttons to
•Select Pix By Pix from the Display Position menu and set it to Enable to have the PlasmaView map a 1920x1080 input signal to 1080p HD panel pixels, displaying 100% of the original content. By skipping the scaling process, the PlasmaView can produce
When Pix By Pix mode is disabled, the picture source is scaled for
1. Pix By Pix is available only when the input signal is 1080i or 1080p.
Note
2. You cannot adjust the Width or Height when Pix By Pix is enabled.
Vidikron PlasmaView Owner’s Operating Manual | 41 |