1.Turn on your source components.
2.Plug the female end
of the power cord into the AC receptacle on the rear of the PlasmaView. Connect the other end to your AC power source.
3.Similarly connect the VHD Controller to a nearby AC outlet.
4.Press the main power switch at the front of the PlasmaView (see Figure
5.Set the main power switch at the rear of the VHD Controller (see Figure
6.Press the ON button on the remote control to turn
on the VHD Controller and PlasmaView (or press the power button on the front of the VHD
Controller). The power indicator on the VHDLIGHT Controller lights solid blue.
7. After a brief | OFF | ON |
seconds), the PlasmaView will display an image. |
|
|
4Operation
4.1
Turning on the Power
Vidikron PlasmaView Owner’s Operating Manual | 27 |