Teledyne IGE 3000 instruction manual Table of Contents

Table of Contents

1.	QUICK START INFORMATION		5
2.	GENERAL INFORMATION		6
	2.1.	GENERAL INFORMATION	6
	2.2.	IGE-3000 MINI BAYARD/ALPERT (B/A) TUBE	6
	2.3.	SPECIFICATIONS	6
	2.4.	MATERIALS EXPOSED TO VACUUM	7

3. INSTALLATION		8
3.1.	INSTALLATION	8
3.2.	RECEIVING INSPECTION	8
3.3.	MOUNTING	8
3.4.	GROUNDING	8
3.5.	“D” CONNECTOR ELECTRICAL PIN OUTS	9
3.6.	B/A TUBE INSTALLATION	9
3.7.	MOUNTING B/A TUBE TO IGE-3000 ELECTRONICS MODULE	9
3.8.	ENVIRONMENTAL:	9

4. OPERATION		10
4.1.	OPERATION	10
4.2.	FRONT PANEL OVERVIEW	10
4.3.	OPERATING MODES	11
4.4.	REMOTE FILAMENT CONTROL	12

5.	THEORY OF OPERATION		14
6.	SET UP GUIDE		15
	6.1.	ADVANCE SETUP GUIDE	15
	6.2.	RS485 ADDRESS	15
	6.3.	BAUD RATE	15
	6.4.	DATA BITS/PARITY BITS/STOP BITS	16
	6.5.	TURNAROUND DELAY	16
	6.6.	SAVE EEPROM	16
	6.7.	RESTORE EEPROM	16

7.	RS 232/RS 485		17
	7.1.	RS232/RS485	17
8.	DEVICE STATUS		18
	8.1. ION GAUGE DEVICE STATUS: 4-DIGIT OCTAL WORD		18
	8.2.	COMMAND SYNTAX	18
	8.3.	INTERROGATION COMMANDS	19
	8.4. PARAMETER MODIFICATION COMMANDS		19
9.	WARRANTY		20
	9.1.	WARRANTY REPAIR POLICY	20
	9.2.	NON-WARRANTYREPAIR POLICY	20
10.		DRAWINGS & SCHEMATICS	21

169-082010_Ion-Gauge-3000 Page 3 of 21