Teledyne IGE 3000 instruction manual Drawings & Schematics

Page 21

10.Drawings & Schematics

High Low

F1

F2

Emis DGas SP K Fil

2X=On/Off

HASTINGS

169-082010_Ion-Gauge-3000

Page 21 of 21

Image 21

Contents Teledyne Hastings Manual Print History Table of Contents 169-082010Ion-Gauge-3000 To Turn on the TUBE’S Filaments Quick Start InformationGeneral Information SpecificationsGeneral Information IGE-3000 Mini Bayard/Alpert B/A TubeMaterials exposed to Vacuum Installation InstallationReceiving Inspection MountingB/A Tube Installation Connector Electrical Pin outsMounting B/A tube to IGE-3000 Electronics Module EnvironmentalOperation Apply PowerOperation Front Panel OverviewOperating Modes Factor Mode DGas ModeFil filament Mode SP set point ModeRemote Filament Control Bayard Alpert B/A Tube Theory of OperationAdvance Setup Guide Set Up GuideRS485 Address Baud RateRestore Eeprom Turnaround DelayData Bits/Parity Bits/Stop Bits Save EepromWiring for IGE-3000 RS232/485 Wiring for RS232/485 RS 232/RSRS232/RS485 Command Syntax Device StatusION Gauge Device Status 4-DIGIT Octal Word Interrogation Commands Parameter Modification CommandsCommand Description Format Sample Response Non-Warranty Repair Policy Warranty Repair PolicyDrawings & Schematics

Related manuals

Manual 21 pages 23.15 Kb