When using remote control
Preparing the remote control
Insert the batteries into the remote control so you can use it to operate the DVD video player.
Make sure to match the +and - on the lithium button cell(3V, CR2025) to the marks inside the cell compartment.
1) Open the cover, |
|
pull the cover as illustrated | 2)Insert cell (3V),Close the cover |
Operating with the remote control
1)This section shows you how to use the remote control. Point the remote control at the remote sensor and press the buttons. Not used when using the remote sensor on the remote control eye jack.
The remote range: about 4m from the front of the remote sensor.
(Is) off axis: more than 30L in each direction of the front of the remote sensor.
2)Remote sensor and remote control eye jack Connect the remote control eye jack to the remote sensor unit.
With about 4m
DVD player
Remote sensor
Remote eye jack
Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD player via the remote control.
Notes on battery
To operate the remote control correctly, follow the instructions below.
Do not insert cell into the remote control in the wrong direction.
Do not charge, heat, open, or
If the remote control does not function correctly or if the operating range becomes reduced, replace all cell with new one.
Notes on the remote control
Direct the remote control at the remote sensor of the DVD player. Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place. Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
7