Esoteric D00864200A manual For U.S.A

Page 3

WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

<DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN!

<IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT, CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.

<USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968“, and is classified as class 1 laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings.

The label required in this regulation is shown .

For U.S.A.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the equipment and/or the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Changes or modifications to this equipments not expressly approved by TEAC CORPORATION for compliance will void the user’s warranty.

Optical pickup :

 

Type

: SLD6163RL-G

Manufacturer

: SONY CORPORATION

Laser output

: Less than 1mW on the objective lens

Wavelength

: 785±15 nm (CD), 655±10 nm (DVD)

 

 

VARING: APPARATEN INNEHÅLLER LASER KOMPONENT MED STRÅLNING ÖVERSTIGANDE KLASS 1.

“ADVARSEL: USYNLIG LASERSTRÅLING VED ÅBNING NAR SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION. UNDGÅ UDSAETTELSE FOR STRÅLING”

“VAROITUS! SUOJAKOTELOA EI SAA AVATA. LAITE SISÄLTÄÄ LASERDIODIN. JOKA LÄHETTÄ (NÄKYMÄTÖNTÄ) SILMILLE VAARALLISTA LASERSÄTEILYÄ”.

ADVARSEL: USYNLIG LASERBESTRÅLING NÅR DENNE DELEN ER ÅPEN OG SIKKERHETSSPERREN ER UTKOBLET UNNGÅ UTSETTELSE FOR STRÅLING.

3

Image 3
Contents DVD/DVD-A/SACD/CD Player Important Safety Instructions For U.S.A Contents Features Conventions about This Manual Placement of the unitBefore Use What’s in the boxRestoring factory settings Changing the Color System NTSC/PALAbout MOD.Modulation PAL Discs Type of Discs That Can be Played on This SystemSacd Example of Icons used on DVD discs Following discs cannot be played with this unitTV Monitor Connection to a TVVideo output terminal DVI-D video output terminalD1/D2 video output terminals component Component video output terminalsConnections to an amplifier, etc Analog audio output terminals Word sync connectorSignal GND connection Power cord receptacleFront panel features Front panel display Understanding the remote control unit How to insert the batteries On-screen menu PlaybackOpening and closing the tray Pausing playback freezing the pictureResume mode Stopping playbackSelecting the playback area Selecting groups and titlesSkipping playback Selecting a chapter or trackTitle, group, disc repeat Repeat modeFast scanning Chapter and track repeatWhen selecting tracks from a DVD audio disc Programmed playbackFinish the programming by pressing Play Clearing the whole program Changing camera angleClearing the last track from the list Adding tracks to the listFrame advance Slow motion/frame advanceSelecting audio Slow motionDisplay dimming Use the FL Dimmer button to cycle between these settingsSelecting subtitles Lip syncDVI output aspect ratio DVI outputDVI output format DVI levelAnalog sound output 2CH/MULTI Clock ModeDown mode Turning video on and offDVD video stopped, on-screen display Changing the display modeDVD video playback main unit display DVD video playback on-screen displaySACD/CD/video CD stopped, main unit display DVD audio playback on-screen displayDVD audio stopped, on-screen display SACD/CD/video CD playback main unit displayEnter the menu item with the right cursor button Settings introductionExit the setup mode by pressing Setup once more Use the cursor buttons to navigate the menusCD Digital Direct Settings AudioAnalog output settings Digital output settingsGroup playback mode DVD audio Audio DRC Dynamic Range ControllingDownmix Enter Settings VideoVideo adjustment Progressive scan settingDisplaying subtitles Settings LanguageAudio language selection Subtitle language selectionLanguage Code Language Code ListSpeaker levels Settings General/Speaker setupSpeaker Size Speaker distanceSettings General Test tone lengthDigital output formats Settings General/Video Out TV screenVideo output Closed captioning Still modeComponent video output PAL-NTSC conversionParental Control Settings General/DisplayPlaying a controlled disc Setting the level of controlResetting the password Country CodeOFF Link Audio Output Setting60958 PCMData transfer rate How to connect multiple i.LINK-capable devicesLink Ieee Copyright protection system DtcpTroubleshooting Beware of condensation MaintenanceSpecifications Sacd Block DiagramTeac Esoteric Company