Precoded AMP, CD, or Tape buttons

USING THE REMOTE TO

CONTROL AUDIO EQUIPMENT FUNCTIONS

Operating the precoded function for your audio equipment.

This remote is designed to operate certain types of audio equipment. You must first program the remote to match the remote system of your audio equipment. (Refer to page 33.)

1.Set the MULTI-PAGE select switch to AUDIO.

2.Turn ON the audio component you wish to control with your remote control (AMP, CD, or TAPE).

3.Aim the remote control at the front of your audio equipment.

4.Hold down the button on the remote which corresponds with the component you wish to control (AMP, CD, or TAPE), enter the two digit preset code that matches your audio component as shown on page 33. The remote will turn off your audio component when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your audio component. If the audio component does not turn off after five seconds, try a different two digit preset code.

5.The remote will now control your audio component.

6.Repeat steps 2-5 until all audio equipment preset codes are programmed into the remote.

NOTES:

1.If your audio equipment cannot be operated after performing the above procedures, your audio component code has not been precoded into the remote.

2.In the unlikely event that your audio component cannot be operated after performing the above procedures, please consult your audio components operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.If your audio component does not have a power function, the remote will issue another obvious function that the audio component will respond to, such as CD open /close.

5.The default for AUDIO mode is AMP.

6.If you wish to control your receiver or miscellaneous audio equipment, you must follow the remote programming procedure shown above. You may use only the AMP button to program these codes, but note that this button may not be used for more than one component.

7.The LST-CH button will act as your audio component s ENTER button if required.

8.The SLEEP button will act as your audio components 100 button if required.

These buttons transmit the chosen precoded audio component codes.

EXCLUSIVE TV buttons

These buttons are for operating the TV.

POWER

AMP CD TAPE

REC STOP PAUSE

TV/CABLE/SAT

VCR

LST-CH AUDIO

VOL MUTE CH

INFOEXIT

	GUIDE
	L
	I
	G
	H
RECALL	C.S. T

FAV	MENU	FAV
CH		CH
	SVCS SCHED
REC		SELECT

1 2 3

4 5 6

7 8 9

INPUTSLEEP

CLU-615MP