Runco pmn manual Front Panel, On Indicator

Page 11

FRONT PANEL

1 2

3

4

1.ON Indicator

Lights green when the plasma display is operating. When flashing, the indicator is used to indicate error messages. The indicator flashes green once every one second when the (AUTO POWER OFF) function is operating.

2.STANDBY Indicator

This indicator is red during standby mode. The flashing pattern is also used to indicate error messages.

3.Display Stand

Optional accessory for tabletop mount.

4.Remote Control Sensor

Receives the IR (infra-red) commands from the remote control.

10

Image 11

Contents PL-43DHD PL-50DHD Contents High Altitude Operation Features and BenefitsIntroduction Avertissement DOC avis de conformation DOC compliance NoticeTo Avoid Image BURN-IN Limited WarrantyWhat is Covered Under the Terms of this Limited Warranty RIGHTS, Limits and Exclusions Effective Warranty DateImportant Warranty Registration Contact a Runco Authorized Service Center to Obtain ServiceGeneral Overview Quick Setup InstructionsOperation Combination IN/OUT Inputs and ControlsDigital RGB INPUT2 DVI-D jack Front Panel On IndicatorFront Panel DHD Controller DescriptionInputs System Control Interface Rear PanelON/OFF DHD Controller Remote ControlComponent Input DHD Controller Connection ExamplesComposite Video Input Video InputISF Calibration Overall Functional DescriptionDigital Inputs DVI 1 / DVIStep I Connection Quick Setup GuideCalibration and Setup HD and DVI SetupInput Source Menu Description and NavigationOpening Screen Aspect Ratio Page Information ISF PresetsInput Position Units wide Units tall Aspect RatiosRS-232 Communications and Commands Command Parameter Value Stored? Description Min/max IHPOS? PL-43DHD Plasma DimensionsPL-50DHD Plasma PL-43DHD PL-50DHD SpecificationsInput Standards Output ResolutionIncluded Accessories DHD Controller Aspect RatiosAspect Ratio Plasma Service Remote ControlRUMA-010900 11-2-04