Runco pmn manual RS-232 Communications and Commands

Page 23

RS-232 COMMUNICATIONS AND COMMANDS

Baud rate: 19200 (fixed)

Bits: 8

No Parity

All protocol in ASCII format

RS-232 input connector pin numbers:

TxD= Pin# 2, RxD= Pin# 3, GnD= Pin# 5

Command format (single command): command value (i.e. brightness 100).

NOTE: A space (not an underscore) or comma may be used between the command and its value.

Command string format: command, command value, command etc. (i.e. COMPOSITE, BRIGHTNESS 100, ANAMORPHIC, <CR>)

NOTE: In between commands, a comma or space may be used

NOTE: A carriage return must be used after each command or string.

Other notes:

For command strings, a maximum of 255 characters can be used in a single string.

PARAMETER min/max refers to a function’s minimum and maximum value range. Inputting values above or below their range may cause unpredictable (but not fatal) results.

22

Image 23
Contents PL-43DHD PL-50DHD Contents High Altitude Operation Features and BenefitsIntroduction Avertissement DOC avis de conformation DOC compliance NoticeTo Avoid Image BURN-IN Limited WarrantyWhat is Covered Under the Terms of this Limited Warranty RIGHTS, Limits and Exclusions Effective Warranty DateImportant Warranty Registration Contact a Runco Authorized Service Center to Obtain ServiceGeneral Overview Quick Setup InstructionsOperation Combination IN/OUT Inputs and ControlsDigital RGB INPUT2 DVI-D jack Front Panel On IndicatorFront Panel DHD Controller DescriptionInputs System Control Interface Rear PanelON/OFF DHD Controller Remote ControlComponent Input DHD Controller Connection ExamplesComposite Video Input Video InputISF Calibration Overall Functional DescriptionDigital Inputs DVI 1 / DVIStep I Connection Quick Setup GuideCalibration and Setup HD and DVI SetupInput Source Menu Description and NavigationOpening Screen Aspect Ratio Page Information ISF PresetsInput Position Units wide Units tall Aspect RatiosRS-232 Communications and Commands Command Parameter Value Stored? Description Min/max IHPOS? PL-43DHD Plasma DimensionsPL-50DHD Plasma PL-43DHD PL-50DHD SpecificationsInput Standards Output ResolutionIncluded Accessories DHD Controller Aspect RatiosAspect Ratio Plasma Service Remote ControlRUMA-010900 11-2-04