Menu Description and Navigation, Opening Screen

MENU DESCRIPTION AND NAVIGATION

When the MENU button is pressed on either the remote control or the front panel, the main menu will appear on-screen. An example of the main menu is shown to the right. The UP and DOWN buttons on the front panel, and IR Remote Control will move the selected item on the menu.

Opening Screen

•Press ENTER to access the Input Source selection menu

•Press ENTER to access the Aspect Ratio selection menu

•Press ENTER to access the Picture setting menu

•Press ENTER to access the Input Position setting menu

•Press ENTER to access the ISF and Custom Presets menu

•Press ENTER to view information about the controller

Runco Video

Input Source

Aspect Ratio

Picture

Input Position

ISF Presets

Information

The active source is indicated by an arrow to the left of the source; note that in the example to the right, Composite is the current source.

Input Source

Indicates selection has been made for the Input Source selection menu

•Press ENTER to select the Composite input

•Press ENTER to select the S-Video 1 input

•Press ENTER to select the S-Video 2 input

•Press ENTER to select the Component SD input

•Press ENTER to select the HD/RGB 1 input

•Press ENTER to select the HD/RGB 2 input

•Press ENTER to select the DVI 1 input

•Press ENTER to select the DVI 2 input

•Press ENTER to select the HD Pass Thru 1 input

•Press ENTER to select the HD Pass Thru 2 input

To select a source via the main menu, press either the up or down buttons on the remote or front panel and highlight the desired source, and press ENTER. Otherwise, you may select a source by pressing either the left or right arrow buttons (on the remote or front panel) when no menus are on-screen, or by pressing one of the direct access buttons on the remote control (recommended).

NOTE: If DVI input is used with HDCP content, RGBHV output is automatically disabled. This is in compliance with HDCP regulations.

Input Source

Composite

S Video 1

S Video 2

Component SD

HD/RGB 1

HD/RGB 2

DVI 1

DVI 2

HD Pass Thru 1

HD Pass Thru 2

If pass-through is selected, note that no on-screen menus will be displayed since the signal is simply being ‘looped’ directly through the analog output. When pass-through is the selected source, pressing MENU will not automatically select the last selected input before Pass-through was selected. If you wish to choose another source, Runco recommends using the direct access buttons to select the desired source as opposed to pressing MENU. Pass-through is not available when the DVI output is in use.