DHD Controller Remote Control, On/Off

DHD ™ Controller Remote Control

(1) ON/OFF

Switches Power ON/OFF. (This does not operate when POWER/STANDBY indicator of the main unit is off.)

(2) IR OUTPUT INDICATOR	NOTE: If the remote control loses its
Illuminates when a button in pressed, indicating that an IR signal is being transmitted.	‘memory’ as a result of weak or dead
	batteries, it must be re-programmed for
(3) ENTER BUTTON	the Controller’s code set. To reprogram the
When an item is highlighted on a menu, pressing ENTER will select that item.	remote to the default IR Code Set, press and
	hold the CODE button followed by 1, 7.

(4) CURSOR (▲ / ▼ / ◄ / ►)

Use these buttons to select items or settings and to adjust settings or switch the display patterns.

UP Button: When no menus are present on-screen, the UP button will toggle through aspect ratios in the following order: (RATIO) Anamorphic → Cinema → VirtualWide → Letterbox → Standard (4:3)

LEFT Button: When no menus are present on-screen, the LEFT button will toggle through the different sources in the following order: (INPUT) HD Pass Thru 2 → HD Pass Thru1 → DVI 2 → DVI 1 → HD/RGB2 → HD/RGB 1 → Component SD → S-Video 2 → S-Video 1 → Composite

DOWN Button: When no menus are present on-screen, the RIGHT button will toggle through the different sources in the following

order: (RATIO) Standard (4:3) → Letterbox → VirtualWide → Cinema → Anamorphic

RIGHT Button: When no menus are present on-screen, the RIGHT button will toggle through the different sources in the following

order: (INPUT) Composite → S-Video 1 → S-Video 2 → Component SD → HD/RGB 1 → HD/RGB 2 →DVI 1 → DVI 2 → HD Pass Thru 1 → HD Pass Thru 2

(5) LIGHT BUTTON

Press this to illuminate the buttons.

(6) MENU BUTTON

Pressing this button will access the OSD (On-Screen Display) controls. Press this button during the display of the sub-menu to return to the previous menu, or exit the OSD menus.

(7) VIDEO BUTTON

Press this button to select VIDEO (composite video) as the source.

(8) COMP BUTTON

Press this button to select Component SD (480i/576i) input.

(9) DIRECT ACCESS BUTTONS

These red buttons to the right hand-side will allow you direct access to an aspect ratio, based on the format of the input signal. These buttons are:

ANA - selects Anamorphic (16:9) widescreen aspect ratio LETBOX - selects Letterbox format aspect ratio

4x3 - selects Standard 4:3 aspect ratio V-WIDE- selects VirtualWide aspect ratio

(10) S-VID 1 and S-VID 2 BUTTONS

Press this button to select between the S-Video 1 and S-Video 2 inputs.

(11) HD1 and HD2 BUTTONS

Press this button to select between HD1 (High Definition) signal and HD2 signal inputs. These inputs can auto-detect input signals between YPbPr and RGBHV.

(12) DVI 1 and DVI 2 BUTTONS

Press this button to select between the DVI1 signal and DVI2 signal inputs. 13