Runco CX-OPAL47, CX-OPAL42, CX-OPAL55, CX-65HD, CX-55HD, CX-42HD, CX-47HD operation manual Status LED

Controls and Functions

5.STATUS LED

Lights orange to indicate that the Crystal Series LCD is in standby mode; Off during normal operation or if the main power switch is set to off.

6.KEYPAD

You can use the keypad instead of the remote control unit to operate the on-screen display (OSD) controls. The keypad operates as follows:

On/Standby ( )

Press once to toggle from standby mode to on mode. Press it again to return to standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control unit (refer to Crystal Series LCD Remote Control on page 13).

SOURCE

To select a source, press the SOURCE button repeatedly (with no menus visible on-screen).

(Volume +)

Use this button to increase the sound volume. When a menu is visible on-screen, this button operates identically to the right-arrow (or ENTER) button on the Crystal Series LCD remote control unit.

(Volume -)

Use this button to decrease the sound volume. When a menu is visible on-screen, this button operates identically to the left-arrow button on the Crystal Series LCD remote control unit.

/

When a menu is visible on-screen, these buttons operate identically to the up- and down-arrow buttons on the Crystal Series LCD remote control unit.

SOURCE

MENU/EXIT

MENU/EXIT

Press this button to access the on-screen display (OSD) controls, or to exit the current menu and return to the previous one.

Crystal Series LCD Installation/Operation Manual 7