Sanyo DSR-M manual Installation and Connections, Basic connections, System controller connections

3

INSTALLATION AND CONNECTIONS

This section describes how to connect the digital video recorder to the CCTV camera and other devices. Be sure to read the instruction manuals for each connected device. Make connections carefully. Improper connections can cause smoke or malfunctions.

Basic connections

The connections for the camera, TV monitor, microphone and PC are shown below. CCTV camera (sold separately)

PC (sold separately)

or

switch (sold separately)

Microphone	Audio input
(sold separately)	terminal

TV monitor (sold separately)

Video input terminal

Amp	*
(sold separately)

AUDIO		LAN						VIDEOVIDEO
IN	OUT				MIC IN		IN	LOOPOUTOUT	OUT
									TV SYSTEM
									NTSC
									PAL
		ADDRESS					NON REC OUT/
							SERIES REC OUT ALARM IN
						CLOCK	SERIES	ALARM RESET
		RS485			REMOTE	ADJ	REC IN	ALARM OUT
TV	RS485								WARNING OUT
									FULL OUT
SYSTEM TERMINATE		A	B	C	C	IN OUT		C
NTSC	ON

PAL	OFF
	ALL
AC IN	RESET

*

*

All cables are sold separately.

Use a shielded LAN connection cable, and wind it once around the supplied ferrite core.

System controller connections

The connections for a system controller are shown below. Use a twisted-pair cable (sold separately) to connect rear panel control terminals A, B and C (ground). Connect signal A to signal A, and signal B to signal B.

RS485

A B C

Connecting a remote control circuit

The connections for a remote control circuit are shown below. Making the connections shown below lets you operate the digital video recorder by remote control.

zCreate the remote control circuit shown in the illustration, and connect it to the remote control input terminals (among the control terminals).

To signal B

Twisted-pair cable

To signal A

GroundRS-485

terminal

AN

MIC IN

RS485 REMOTE

A B C

				RO 1.2K
				R1	0.3K
				R2	0.43K
		VIDEO		R3 0.51K
IN		LOOP OUT OUT
				R4	0.62K
NON REC OUT/				R5	0.75K
SERIES REC OUT ALARM IN
CLOCK	SERIES	ALARM RESET		R6 0.91K
ADJ	REC IN	ALARM OUT	WARNING OUT
C IN OUT		C	FULL OUT	R7	1.1K
				R8	1.3K
			ALL	R9	2.0K

RESET

R10 2.4K

R11 3.6K

R12 5.6K

SW1:STOP

SW2:PAUSE/EXIT

SW3:REW

SW4:FF

SW5:PLAY

SW6:REC

SW7:MENU

SW8:SEARCH(REVERSE) SW9:

SW10:

SW11: (SHIFT/OSD)

SW12:(SHIFT )

System controller (sold separately)

zTwisted-pair cable

Can reduce interference on the signal caused by noise generated by other cables.

( ): When VA-RMN01 is used

Use a resistance of 1/10 ohms or more and with a D ranking (precision 0.5% or finer).

zIn order to stop recording using the remote-control REC button, “REMOTE SET” must be set. (JP.41)

English 9