Sanyo DSR-M manual Settings, Starting recording again when Full indicator lights

2 REC MODE SET

Settings

[MENU] button [ ] button [ ] button

[ ] button [EXIT/OSD] button

1 Press the [MENU] button.

The MENU indicator lights, and the <MAIN MENU> screen appears.

2 Select “2. REC MODE SET”, and press

the [ ] button.

The <REC MODE SET> screen appears.

3 Press the [ ] and [ ] buttons to select

the desired item, then press the [ ] button.

4 Press the [ ] and [ ] buttons to change

the setting, then press the [ ] button.

5 Use the same procedure to set the other items as needed.

6 Press the [EXIT/OSD] button.

The display returns to the normal screen.

Connecting several digital video recorders to make series recordings

Use a cable to connect the control terminals as shown in the following.

1st	2nd
DVR	DVR

3rd

DVR

Starting recording again when the

FULL indicator lights

When “OVER WRITE” is set to “OFF” and the hard disk becomes full, the FULL indicator lights and recording stops. To start recording again, first follow the steps below to erase the images recorded so far.

[ ] button [ ] button

FULL indicator [ ] button SETTINGS

1 Display the <REC MODE SET> screen.

2 Press the [ ] or [ ] button to select “DISK FULL RESET”, then press the

[ ] button.

The <DISK FULL RESET> screen appears with “NO” flashing.

3 Press the [ ] or [ ] button to select

“YES”, then press the [ ] button.

The images recorded so far are erased, and the display returns to the normal screen.

The FULL indicator goes out, and you can record until the disk becomes full.

30 English