POSITIONING THE LCD | GETTING STARTED |
HDTV | BATTERY INSTALLATION |
•Always use a firm and flat surface when positioning your HDTV.
•Do not position the unit in a confined area.
•Allow adequate space for proper ventilation.
STAND REMOVAL AND WALL MOUNTING (OPTIONAL)
Tools Needed: Phillips screwdriver
IMPORTANT NOTE: Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish.
Wall mounting of the HDTV must be performed by a skilled person.
1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.
2Use the screws you removed when detaching the stand to secure the HDTV to a wall mounting kit (not included.)
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter,
Need help?
Install two (2) “AAA” batteries in the remote control. (Not included)
To ensure safe operation, please observe the following precautions:
•Replace both batteries at the same time. Do not use a new battery with a used battery.
•There’s a risk of explosion if a battery is replaced by an incorrect type.
•Do not expose the Remote Control unit to moisture or heat.
•Be sure to match the “+” and
ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE
Hook up your antenna or your cable service to the HDTV’s ANT terminal with the use of a 75 OHM coaxial cable.
NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment.
ANTENNA
ANALOG / DIGITAL
ANTENNA IN
CABLE
The tuner in this HDTV can receive:
•Digital and Analog off air signals from an antenna
•Analog or ClearQAM cable channels from a direct Cable TV connection.
www.sanyoctv.com 