Sanyo DP19640 manual Cable TV connections, Cable TV Jack, Ohm Cable to TV, 75 ohm

Page 14

Cable TV connections

This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company.

For subscribers to basic Cable TV service

For basic Cable TV service not requiring a Converter/ Descrambler box, connect the 75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV.

Antenna

Jack

75 ohm Coaxial Cable

For subscribers to scrambled Cable TV service

If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler box to the Antenna Jack on the TV. Follow the connections shown below. Set the TV to the output channel of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels.

Incoming

 

 

75 ohm

 

Antenna

Cable TV

 

Jack

Cable

Converter/

75 ohm Cable to TV

 

Descrambler

 

For subscribers to unscrambled Cable TV service with scrambled premium channels

If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a Converter/Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available from the Cable TV company or an electronics supply store). Follow the connections shown below. With the switch in the “B” position, you can directly tune any nonscrambled channels on your TV. With the switch in the “A” position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to tune scrambled channels.

Incoming

 

Converter/

 

 

75 ohm

 

 

Antenna

 

Descrambler

 

Cable TV

 

 

 

Jack

Cable

Splitter

A/B Switch

A

75 ohm Cable to TV

 

B

14

Image 14
Contents Español Français English Obligations Warranty ApplicationHOW to Make a Claim Under this Warranty Model NoTrademarks Page Voltage surges and built-up static Wire to an antenna discharge unit, sizeTo provide some protection against Charges, of the NationalTune Into Safety Child SafetyIssue This Manufacturer CaresHOW to Handle the LCD Panel CondensationHow to attach the stand How to remove the standTo USE AC Power FeaturesPower source Contents Right side Rear Parts and functionsFront Battery Precautions CH Channel + / / CursorAntenna connections Cable TV Jack Cable TV Jack Splitter Switch Ohm Cable to TVCable TV connections Ohm Cable to TVTo connect the LCD TV to a VCR with an S-Video cord Connections to other equipmentTo connect the LCD TV to a VCR To connect the TV to a camcorder, or a TV GameTo Hdmi out Hdmi device To PC/HDMI Using an AV Amplifier with built-in digital surroundTo connect a Hdmi or a DVI device to the unit Aspect Ratio To connect the TV to a PC Personal ComputerRGB VerticalTV operation To select the video input sourceQuick guide for menu operation You can change the default settings to convenience use Convenience functionsAir/Cable selection Cable ChartMemorizing channels Automatic searchTo clear a Ch Label Labeling video inputsClear All Or EnterTo change the password Setting the V-ChipTo register a password To set the V-ChipCC advanced To clear the all V-Chip settingsClosed Caption Setting the picture size Reception disturbances IgnitionTroubleshooting Symptoms Possible SolutionsGeneral SpecificationsAccessories Memo J3AI0331A SH 10/02 K