Sanyo DP19640 manual How to attach the stand, How to remove the stand

Page 8

How to attach the stand

NOTE:

•Unplug the AC cord from the AC INPUT terminal.

•Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any damage to the unit.

•Do not touch or press the TV-screen, glass might break under pressure.

Place the TV on its back onto a table.

Align the stand’s bottom-plate (supplied) as seen here.

It will ﬁt in only one direction.

Hold the unit and attach the stand slowly.

Please assure “ ” mark on the stand is facing the LCD panel side.

Finally secure the bottom-plate with 2 screws (supplied).

• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

How to remove the stand

When you transport this product, remove the stand and pack ﬂat against the back of the unit in the carton. To remove the stand, perform the step in reverse order.

For wall mounting, the base must be removed. To disconnect the base/stand remove the two (2) screws from the back (see page 7).

8

Image 8

Contents Español Français English Warranty Application HOW to Make a Claim Under this WarrantyObligations Model NoTrademarks Page Wire to an antenna discharge unit, size To provide some protection againstVoltage surges and built-up static Charges, of the NationalChild Safety IssueTune Into Safety This Manufacturer CaresHOW to Handle the LCD Panel CondensationHow to attach the stand How to remove the standTo USE AC Power FeaturesPower source Contents Right side Rear Parts and functionsFront Battery Precautions CH Channel + / / CursorAntenna connections Cable TV Jack Splitter Switch Ohm Cable to TV Cable TV connectionsCable TV Jack Ohm Cable to TVConnections to other equipment To connect the LCD TV to a VCRTo connect the LCD TV to a VCR with an S-Video cord To connect the TV to a camcorder, or a TV GameTo Hdmi out Hdmi device To PC/HDMI Using an AV Amplifier with built-in digital surroundTo connect a Hdmi or a DVI device to the unit To connect the TV to a PC Personal Computer RGBAspect Ratio VerticalTV operation To select the video input sourceQuick guide for menu operation You can change the default settings to convenience use Convenience functionsCable Chart Memorizing channelsAir/Cable selection Automatic searchLabeling video inputs Clear AllTo clear a Ch Label Or EnterSetting the V-Chip To register a passwordTo change the password To set the V-ChipCC advanced To clear the all V-Chip settingsClosed Caption Setting the picture size Reception disturbances IgnitionTroubleshooting Symptoms Possible SolutionsGeneral SpecificationsAccessories Memo J3AI0331A SH 10/02 K