DISPLAY
Press DISPLAY to display the current information on the screen.
When the TV receives a digital signal, the digital information will appear.
|
| HDTV Moving Picture1 | Sleep Timer |
|
|
| Off |
|
| ||
| Digital Air | English |
|
| |
| No Program Information is available |
|
|
| |
| Full |
|
|
| |
| 1080i |
|
|
| |
• Channel number |
| • | Station name | ||
• | Channel label (if preset) • | Broadcast program name | |||
• |
| • | Signal type | ||
• | Sleep timer |
| • | Audio language | |
• | Program guide |
| • | Picture size | |
• | Resolution |
|
|
| |
When the TV receives an analog signal, the analog information will appear.
14Sleep Timer
OffG
Analog Cable
Mono
Full
480i
• | Channel number | • Channel label (if preset) | |
• | • | Signal type | |
• | Sleep timer | • | Picture size |
• | Audio information | • | Resolution |
| (Stereo, SAP or Mono) |
|
|
Press DISPLAY again to clear the call display.
NOTE:
• After a few seconds, DISPLAY screen will return to normal
RECALL
This button allows you to go back to the last channel selected by pressing RECALL. Press RECALL again to return to the last channel you were watching.
MUTE
Press MUTE to switch off the sound. The TV’s sound will be silenced and “Mute” will appear on the screen. The sound can be switched back on by pressing this button again or the VOL + or
SLEEP
To set the TV to turn off after a preset amount of time, press SLEEP on the remote control. The clock will count up 10 minutes for each press of the SLEEP but- ton (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is operating. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to Off.
Quick guide for menu operation
Call menu and for example: Select Language. 1 Press INPUT SELECT to select TV mode.
2 Press MENU. The TV menu screen will appear.
Main Menu
Picture
Audio
CH Channel
Lock
Setup
3 | :Select |
| ENTER :Set |
Press | or | to select “Setup”, then press or | |
ENTER. |
| ||
4 | Press | or | to select “Language”, then press |
or | to select the desired language. | ||
…on the following pages the menu can be called in the same way as here.
5 Press EXIT to return to the normal screen.
NOTE:
• If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically.
18
3FR0321A_En.indd 18
1/7/11 4:32:13 PM