Sanyo DP19241 owner manual How to attach the stand, How to remove the stand

Page 8

How to attach the stand

NOTE:

•Unplug the AC cord from the AC INPUT terminal.

•Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any damage to the unit.

•Do not touch or press the TV-screen, glass might break under pressure.

1.Place the TV on its back onto a table.

Align the stand’s bottom-plate (supplied) as seen here. It will fit in only one direction.

Hold the unit and attach the stand slowly.

LCD PANEL SIDE

2.Finally secure the bottom-plate with 2 screws (supplied).

• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

How to remove the stand

When you transport this product, remove the stand and pack ﬂat against the back of the unit in the carton. To remove the stand, perform the step below.

1.Place the TV on its back onto a table.	2. Pull the stand toward you again and remove the
Remove 2 screws with the bottom-plate.	stand from the TV.

For wall mounting, the base must be removed. To disconnect the base/stand remove the three (3) screws from the back (see page 7).

8

3FR0321A_En.indd 8

1/7/11 4:32:01 PM

Image 8

Contents DP19241 Obligations Warranty ApplicationHOW to Make a Claim Under this Warranty Trademarks Location of the required Marking To provide some protection against Child Safety IssueTune Into Safety This Manufacturer CaresHOW to Handle the LCD Panel CondensationHow to attach the stand How to remove the standTo USE AC Power FeaturesPower source Contents Parts and functions FrontRear Right sideRemote control Battery PrecautionsAntenna connections Combination VHF/UHF Antenna Single 75 ohm cableConnections to other equipment To connect the LCD TV to a VCRTo connect the LCD TV to a camcorder, or a TV Game Left of the unitUsing an AV Amplifier with built-in digital surround Connections to other equipmentTo connect the TV to a PC Personal Computer RGBAspect Ratio VerticalTo select the video input source To Select Analog ChannelsEnter To Select Digital ChannelsQuick guide for menu operation DisplayIcon Selected Items Setup hint Convenience functionsMemorizing channels Air/Cable selectionAutomatic Search Adding ChannelChecking the digital signal strength Labeling channelsClear All To create channel labelsSetting the V-Chip To register a passwordTo change the password To set the V-ChipCC advanced To clear the all V-Chip settingsClosed Caption Setting the picture size Reception disturbances IgnitionTroubleshooting Symptoms Possible SolutionsGeneral SpecificationsAccessories