INSTALLATION
Please make sure that you have read the
Step : 1 Connections ( Essential)
Connect your aerial cable socket to the back of the TV set. Fit the aerial cable as shown below or as shown opposite when AV equipment is con- nected.
AV2 | AV1 |
ANT.75Ω
Connect the power cord of the TV set to a wall outlet.
✐The TV set is prepared for a mains voltage AC220~240V, 50Hz.
WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.
When the TV set is not to be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet.
✐For all aerial problems please consult your local dealer.
Important:
This equipment is fitted with an approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:
1.Remove the fuse cover and fuse.
2.Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI approved type.
3.Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a rating of 5 Amp, ensure the fuse cover is correctly fitted. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13Amp socket elsewhere.
The wires in this mains lead are coloured in accordance with the following code:
Blue | > | Neutral |
Brown | > | Live |
1.The Blue wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.
2.The Brown wire must be connected to the terminal with the letter “L” or coloured RED.
3.Do not connect either wire to the earth terminal in the symbol or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the wires.
●Connecting DVD / VCR player or Satellite receiver.
We recommend that you connect all other equipment before Plug and Play. The following examples are our recommended standard connection. For further information please consult your local dealer.
TV rear panel |
|
AV2 | AV1 |
| ANT.75‰ |
Option if no DVD |
|
VCR | OUT |
| IN |
Satellite | DISH | OUT |
| IN | |
VCR | TV IN |
For Satellite only
DVD
Please refer to individual Instruction Manuals for each piece of equip- ment for their connection suggestions.
Step : 2 Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and
3