Chapter 3 - Network Installation | 9 |
Chapter 3 - Network Installation
Figure 1. IntraPort 2/2+ VPN Access Server Back Panel
This section of the manual describes how to connect the IntraPort 2/2+ VPN Access Server to your Ethernet network. In summary, the steps for installation are:
1.Make sure the server is powered down and not connected to any power source.
2.Connect the server to the Ethernet network(s).
3.Connect a management console to the server (optional).
4.Plug in the power cable and power up the server.
Placing the Server
The IntraPort 2/2+ VPN Access Servers are meant to be left
ϖNote: When stacking other equipment on the IntraPort 2/2+, do not exceed 25 pounds of evenly distributed weight on top of the device. Additional weight may bend the case.
Connecting the Server to the Ethernet
Because Ethernet 1 is
Ethernet 1 should only be used if you are planning to set the IntraPort 2/2+ to operate in parallel with your existing firewall. This is the recom- mended setup. In this scenario, Ethernet 1 should be connected to the same Ethernet segment as your Internet gateway router while Ethernet 0 will serve as an IP, IPX and AppleTalk router port for your internal networks.