Dish Network 11, 6.2 Switch Dish PLAYER-DVR 942 only, Changing the UHF Frequency Using the A/B

Page 19

3.Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote in step 1.

4.Press POUND (#). If you entered the address correctly, SAT will flash three times.

Write down the number you entered in Your Remote Control Codes on page 24.

5.Press RECORD. Make sure the Remote Address you see on the System Information screen is the same as the one you entered in step 3. If it isn't, the remote cannot control the receiver.

6.Press SELECT to close the System Information screen.

CHANGING THE UHF FREQUENCY USING THE A/B

SWITCH (DISH PLAYER-DVR 942 ONLY)

All receiver models except the DISH Player-DVR 942 must use switch position A or else your remote control will not work.

Your remote has a switch to change the UHF frequency that your remote control uses. It comes preset to the A position but you can change the setting to the B position to lessen the likelihood of any other UHF remote interfering with yours. This feature is available only with the DISH Player-DVR 942.

1.Remove the battery cover from the remote control.

2.Use a small screw driver or a paper clip to carefully change the setting.

3.Put the battery cover back on the remote control.

4.Use the SYS INFO button on the front panel to open the System Information screen.

5.Press RECORD on the remote control.

6.Make sure the System Information screen shows the correct band information:

Switch position A - IR/UHF Pro Band A

Switch Position B - IR/UHF Pro Band B

A

B

Battery

9

Image 19
Contents If your Receiver Insert the Batteries Install Your Selected KeyMaking the Remote Work With Your Receiver Pound Program the Remote to Control Your TVFor TV2 Remote Controls on 942, 625, & 522 Receivers Programming Recover Button for TV2 OperationButton Placing Your Remote Limited ModePage Remote Operation TV ModeVCR Mode Table of Contents Using the Guide Remote Control OverviewRemote Control Modes Programming for Other Equipment HOW the Remote CommunicatesCombination Equipment for EXAMPLE, TV/VCR Programming Using Equipment Code Tables Limited ModeScanning for Equipment Codes Press Pound #Instructions Additional Information Control Amplifier Volume Switching Between TV and Amplifier Volume ControlReading OUT the Remote Control Codes Changing the Remote and Receiver Address Avoiding Remote ConflictsChanging the UHF Frequency Using the A/B Switch Dish PLAYER-DVR 942 onlyDish PLAYER-DVR 522 and 625 only Setting UP a TV1 UHF PRO Remote forTV Out Equipment Codes TV CodesTV Codes VCR Codes Motorola Schneider RicohMatsushita Saisho Salora 567DVD Player Codes TUNER/AMPLIFIER CodesBroksonic Samsung Goldstar Sylvania Panasonic Zenith Quasar TV/DVD Combo CodesTV/VCR Combo Codes DVD/VCR Combo CodesWhat’s What’s Wrong What You Can Do Happening TroubleshootingSee Programming the Remote to Advance Exchange Program Limited WarrantyIf YOU Need Help Accessory WarrantyPost Receipt Exchange Program Page AUX Reference Tables