Instructions | Additional Information |
2Press the POUND (#) but- ton twice. The mode button flashes the number for each digit of the equipment code, with a pause between the groups of flashes. A quick flash is for zero.
For AUX mode, the first group of flashes tells you what the AUX mode controls. A quick flash (zero) before the
For example, if the code is 570, the mode button flashes five times, pauses, flashes seven times, pauses, and flashes once quickly.
For example, if the TV code is 570, the AUX mode button flashes once quickly, pauses, flashes five times, pauses, flashes seven times, pauses, and flashes once quickly.
AVOIDING REMOTE CONFLICTS
Because your remote control uses UHF, you may experience interference from other nearby remotes. The instructions in this section describe how to avoid remote conflicts.
CHANGING THE REMOTE AND RECEIVER ADDRESS
One quick way to avoid remote conflicts is by changing the address on your remote and receiver. If you notice that your receiver is changing channels or opening menus but you’re not using the remote control, a quick change of address should fix the problem. Use these instructions to change the remote control and receiver address.
1.Press SYSTEM INFO on the receiver's front panel. The System Information screen displays and shows the Remote Address.
Write down the address shown:
2.Press and hold SAT on your remote control for about three seconds, until all of the mode buttons light up, and then let go of
SAT.
8