Remote Button Shortcuts, DVR Buttons | Dish Network 32.0, 176842

1Make sure the UHF-2G remote antenna is connected to the correct input on the receiver’s back panel and is not touching anything else. It should be tightened only by hand. Note: Remote antennas used with other DISH Network satellite receivers and remotes cannot be used with your ViP922 receiver or remote controls.

2Try varying the tilt angle of the receiver's remote antenna. Locate the antenna’s tip away from any other electronic equipment or metal surfaces, even if separated by wooden shelving.

3Move the satellite receiver to a different location. For best results, place the receiver on as high a surface as possible, above all other equipment in your entertainment center.

4Place the remote antenna away from other equipment by using the optionally available special cable to connect it to the receiver.

5Move any nearby antenna or radio equipment away from the UHF-2G remote antenna. Do not place an over-the-air antenna, WiFi, Bluetooth, or Zigbee devices on or near the remote antenna.

REMOTE BUTTON SHORTCUTS

In addition to their normal functions, some buttons on your remote control have special “shortcut” functions when you are navigating the on-screen Electronic Program Guide (EPG), or inside a drop-down menu of options or scrollable list of events displayed by your receiver.

DVR BUTTONS

The following table lists some of these shortcuts for the black set of buttons that normally control your DVR functions. Note that scheduled updates to your receiver software may add to or modify these shortcuts.

REMOTE BUTTON

IN GUIDE DISPLAY

SCROLLS IN LISTS

SKIP BACK

PLAY/PAUSE

SKIP FWD

FAST REVERSE

FAST FWD

Moves 3 Hours Back		By 1 Screen Upward
Watch highlighted show		No
Moves 3 Hours Ahead		By 1 Screen Downward
24	Hours Back	To beginning of list
24	Hours Ahead	To end of list