Dish Network 32.0, 176842 manual Making the Remote Work With Your Receiver

Page 4

Quick Setup

3 Making the Remote Work With Your Receiver

1

Verify this key is

installed,

and continue

with step 2.

2	3

Verify the
remote antenna
is installed on
the back of	REMOTE
the receiver.	ANTENNA

4

Turn your ViP922 receiver and TV on, and select SYSTEM INFO on the receiver front panel.

5

	Confirm that you
	see the System	Press and release SAT on
	Information screen.	Press and release SAT on
	Information screen.	your remote. After a few
		your remote. After a few
		seconds, you will hear a tone,
		and the remote will be listed
	6	on the screen.
	6

Confirm that your remote operates your receiver by pressing remote buttons. If this is not working, repeat step 5. If the remote is still not linked to your

ViP922 receiver, see page 10 in this guide.

C-3

Image 4

Contents Remote Control Accessing the System Wizard Verify the Key Making the Remote Work With Your Receiver Set Up the Remote to Control Your TV Placing Your Remote Limited Mode SAT Mode TV Mode DVD Mode Page Table of Contents Page Using this Guide Remote Control OverviewRemote Control Modes HOW the Remote Communicates Setting UP for Other EquipmentCombination Equipment for EXAMPLE, TV/DVD Setting UP the Remote to Work with Your Equipment Instructions Additional InformationScroll the Sort By or Entering Equipment Codes Continue Instructions Additional Information Switching Between TV and Amplifier Volume Control Select Remote ControlViewing Equipment Codes Adjusting the AntennaAvoiding RF Interference Remote Button Shortcuts DVR ButtonsLocating a Lost Remote Using the System WizardColored Buttons Page Troubleshooting What’s What’s Wrong What You Can Do HappeningOr Volume Limited Warranty Dish NETWORK’S Exchange ProgramsAccessory Warranty Advance Exchange ProgramSee Troubleshooting on If YOU Need HelpRegulatory Factors PrintedPage 176842