AMX instruction manual Rack-Mounting the AXB-REL8 optional, Testing the installation

Connection and Wiring

A

1
B
A
2
B
A	RELAYS SHARING A COMMON
3
B	Jumper "A" pins with tab strip

A

4	B
5	A
	B
	A

6B

	A	RELAYS WITH DISCRETE COMMONS
7		Wire commons individually
	B

A

8B

FIG. 5 Relay wiring diagram

Testing the installation

1.Check AXlink status LED - it should blink once per second (see Specifications table for AXlink status LED).

2.Relay LED lights, but source does not activate:

3.Check wiring continuity.

4.Check jumpers used for shared commons.

5.Check cable and source against supplied documentation.

6.Check operational status of interface or source.

Rack-Mounting the AXB-REL8 (optional)

To rack-mount the AXB-REL8 into the optional AC-RK Accessory Rack Kit:

1.Remove any connected relay and AXlink connectors from the rear panel.

2.Remove the two screws on the front panel of the AXB-REL8.

3.Remove the front panel and the space bracket behind the panel.

4.Place the unit in the appropriate opening in the AC-RK.

5.Place the front panel of the AXB-REL8 on the front of the rack, over the unit.

6.Fasten the front panel to the rack and to the unit with the two screws you removed.

6 AXB-REL8 Axcess Relay Controller