If the VCR does not detect an EDS signal within this time, AUTO CLOCK SET INCOMPLETE appears. There is proba- bly not an EDS signal available in your area. Press MENU/ACTION, then see “Man- ually Setting the Clock” to set the clock.
Notes:
•Your VCR protects tuner programming for up to 24 hours in case a power failure occurs or if the power cord becomes unplugged. After about 24 hours without power, the VCR loses the programming.
•If you have not connected the VCR to an antenna, cable TV,
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
Manually Setting the Clock
Follow these steps to manually set the clock if EDS is not available in your area, if you do not want the VCR to search for an EDS signal, or if you skipped tuner programming.
Notes:
•The clock must be accurately set for proper automatic timer recording. We suggest you refer to a radio station or time/temperature service for the correct time.
•If you do not press a button within 5 min- utes in Steps
1.Press MENU/ACTION to display the main menu.
RE
NEL
UE: ENGL I SH
Y
KEY
Note: To exit the programming mode at any time, press MENU/ACTION again.
2.Repeatedly press 
(marked above PLAY
on the remote control) or 
(marked below STOP on the remote control) to high-
light SET CLOCK, then press 
(marked to the right of
3.Repeatedly press 
or 
to highlight MANUAL, then press 
.
CK
CK SET
Y
KEY
4.Repeatedly press 
or 
to select the correct month, then press 
.
K
:
DST : ON
KEY
5.Repeat Step 4 to select the correct date, year, and hour, then press 
.
6.Repeatedly press 
or 
to select a minute that is 1 or 2 minutes after the cur- rent time, then press 
. (For example, if it is 42 minutes past the hour right now, enter 43 minutes now.) This gives you time to complete this procedure before starting the clock.Note: Your VCR uses a
7.Repeatedly press 
or 
to set DST (daylight saving time) to ON or OFF.
15