When you set DST to ON, the VCR auto- matically adds 1 hour on the first Sunday in April, and subtracts 1 hour on the last Sun- day in October.
8.Press 
. SET COMPLETED appears.
9.Review the information you entered.
K
12:00PM
DST : ON
KEY
If the information is not correct, repeatedly
press 
(marked to the left of REW on the
remote control) or 
to move the cursor to the incorrect entry, then enter the correct information.
When the information is correct and the time reaches the minute you set in Step 6, press MENU/ACTION twice. The currently set time appears and the clock starts run- ning.
Note: Seconds begin counting from 00 when you press MENU/ACTION twice.
4.Press CH s. The VCR searches for an EDS signal and, if it finds one, automatically sets its clock to the correct time. If the VCR does not find an EDS signal, follow the steps under “Manually Setting the Clock” on Page 15.
Adding/Erasing Channels
We recommend you check the channels the VCR automatically stored. It might have stored distant, weak channels that you normally would not watch, or it might have missed channels you want to store.
If the tuner stores a channel that you do not want, repeatedly press (or hold down) CH s or t or use the remote control’s number buttons to tune to that channel, then press ADD/DLT. CHANNEL nn DELETED appears, and the un- wanted channel is erased from the tuner’s memory.
To add a channel, enter the desired channel number using the number buttons. Then press ADD/DLT. CHANNEL nn ADDED appears, and the channel is added to memory.
Turning On Auto Clock Set
If you turned off the auto clock set feature and manually set the VCR’s clock, then find that EDS is available in your area, you can turn the auto clock set feature back on. This ensures that the VCR automatically sets itself to the correct time after a power failure of less than 24 hours.
Follow these steps to turn on auto clock set.
1.Press MENU/ACTION to display the main menu.
2.Repeatedly press 
or 
to highlight SET CLOCK, then press 
.
3.If necessary, press 
or 
to highlight
AUTO CLOCK SET, then press 
.
16
Reprogramming Tuner Memory
You might want to reprogram the VCR’s tuner memory if you move or change from an anten- na connection to a cable TV connection.
Note: You can also quickly erase all settings, including the time, local channels, and pro- grammed events, then reprogram the tuner’s memory. See “Resetting the VCR’s Memory” on Page 18.
Follow these steps to reprogram the tuner.
1.Press MENU/ACTION to display the main menu.
Note: To exit the programming mode dur- ing Steps
2.Repeatedly press 
or 
to highlight
SET UP CHANNEL, then press 
.