Roland TU-60, TU-70 Operating Conditions for the TU, For Both the CJ and the FJ, For the CJ Only

Page 12

6. Operating Conditions for the TU

The TU takes up material fed from the CJ/FJ. Performing an operation to pull out material from the CJ/FJ generates corresponding force, and so the CJ/FJ displays the error message, and operation stops. When performing printing in particular, such a stop in operation may affect the printing extremely, such as misalignment of the printing location.

*Material can not be taken up with TU when CJ performs cutting. TU can be used only when printing.

OK

CJ/FJ

Material feed

Take-up of fed material

TU

NO GOOD

CJ/FJ

Return of

pulled-out material

Take-up of

fed material

TU

MOTOR ERROR

TURN OFF POWER

The CJ/FJ stops operation

When using the TU, make the settings for the following conditions.

For Both the CJ and the FJ

At the display menu, set [AUTO SHEET CUT] to [DISABLE].

Do not use the [SHEET CUT] key to separate the material.

Do not use the or keys to return the material.

For the CJ Only

Turn off the cutting function on the program you're using.

From the display menu, set [PREFEED] to [DISABLE].

From the display menu, select something other than [ROLL] for the material.

Do not perform automatic detection of the base point or align point when loading material.

When loading material, use the right-hand grit roller (to ensure that the material overhangs the TU sensor area).

For the FJ Only

• Load the material so that it is close to the right-hand side (to ensure that the material overhangs the TU sensor area).

10

Image 12
Contents Automatic media take-up unit EC Electromagnetic Compatibility Directive 89/336/EEC Table of Contents EnglishAbout the Symbols To Ensure Safe UseAbout and Notices Do not disassemble, repair, or modifyHands or hair may become caught About the Labels Affixed to the Unit Rating labelModel name System Configuration Confirmation of Included ItemsInstallation and Assembly Frame and Control Box InstallationFront Rail Slider Installation Installing the Sensor and the Small RetainerTop View Installing the Mirror Power Cord Connection and Large Retainer InstallationArm Installation Front RearAdjusting the Sensors Position Operation PanelOperating Conditions for the TU For Both the CJ and the FJFor the CJ Only For the FJ OnlyLoading Material Mounting the Flange and Paper TubeSide view of flange Loading Rolled Material CorrectIncorrect Correct IncorrectSecuring the Material in Place Printed surface is moved to the outer side and taken upPrinted surface is moved to the inner side and taken up Starting Operation Maintenance Removing MaterialWhat to Do If CJ doesnt runFJ doesnt run TU doesnt take up materialSpecifications TU-60 TU-70 TU-400 TU-500Memo R8-990901