Roland TU-400, TU-60, TU-70, TU-500 user manual Securing the Material in Place

Page 15

Securing the Material in Place

Forward Take-up (FORWARD)

The printed surface is moved to the outer side and taken up

Pull out material so that it is perpendicular to the paper

1 tube.

To prevent the pulled-out material from becoming

2 crooked, secure with tape at the two edges and center, as shown in the figure.

Front

Pull out the material and ensure a certain amount of slack,

3 as shown in the figure. Move the sheet loading lever to secure the material in place.

Move the [MANUAL] switch to the [FORWARD] setting and take up one turn's worth of material.

4 After take-up, maintain slack as shown in the figure to keep the material from being drawn taut by take-up.

Front <---

Backward Take-up (BACKWARD)

The printed surface is moved to the inner side and taken up

Pull out material so that it is perpendicular to the paper

1 tube.

To prevent the pulled-out material from becoming

2 crooked, secure with tape at the two edges and center, as shown in the figure.

Front

13

Image 15
Contents Automatic media take-up unit EC Electromagnetic Compatibility Directive 89/336/EEC English Table of ContentsDo not disassemble, repair, or modify About the SymbolsTo Ensure Safe Use About and NoticesHands or hair may become caught About the Labels Affixed to the Unit Rating labelModel name Confirmation of Included Items System ConfigurationInstallation and Assembly Frame and Control Box InstallationFront Rail Slider Installation Installing the Sensor and the Small RetainerTop View Front Rear Installing the MirrorPower Cord Connection and Large Retainer Installation Arm InstallationOperation Panel Adjusting the Sensors PositionFor the FJ Only Operating Conditions for the TUFor Both the CJ and the FJ For the CJ OnlyLoading Material Mounting the Flange and Paper TubeSide view of flange Correct Incorrect Loading Rolled MaterialCorrect IncorrectSecuring the Material in Place Printed surface is moved to the outer side and taken upPrinted surface is moved to the inner side and taken up Starting Operation Removing Material MaintenanceTU doesnt take up material What to Do IfCJ doesnt run FJ doesnt runTU-60 TU-70 TU-400 TU-500 SpecificationsMemo R8-990901