Roland TU-70, TU-60 Loading Material, Mounting the Flange and Paper Tube, Side view of flange

Page 13

7. Loading Material

Do not attempt to change a roll material while the power remains switched on.

The take-up motor may be activated unexpectedly while changing the roll, leading to injury. The power must be switched off before attempting to change the material.

Roll material must be placed at a predetermined shaft position.

Failure to do so may allow the material to fall, leading to injury.

*For detailed informa- tion on loading material, please refer to the CJ/FJ user's

manual.

NOTICE

When in the manual mode, make sure there is some slack in the material before attempting to perform take-up.

 

 

Mounting the Flange and Paper Tube

1

Pull out the stopper.

Align the flange with the

2 groove on the shaft, and press in all the way.

Follow steps 1 to 3 to mount the

4 flange for the frame as well.

6 Tighten the mounting screws securely.

3

Insert the stopper.

 

 

 

 

5 Mount the paper tube.

When using the core from used-up rolled material as the paper tube

When mounting the paper tube on the flanges, make sure that the paper tube fits snugly. Attempting to take up material when the paper tube is not stable may cause problems such as the pa- per tube coming loose. The outer diameter of the flange portion where the paper tube is fitted is shown below.

Side view of flange

76.2 mm

 

50.8 mm

 

(3 in.)

 

(2 in.)

 

 

 

Make sure the margin described below is present between each flange and the edge of the material. Attempting to take up material when no margin is present may cause the material to touch the flange and result in faulty take-up.

 

Paper tube

 

Sheet

Flange

Flange

20 mm (13/16 in.) or more

11

Image 13
Contents Automatic media take-up unit EC Electromagnetic Compatibility Directive 89/336/EEC English Table of ContentsTo Ensure Safe Use About the SymbolsAbout and Notices Do not disassemble, repair, or modifyHands or hair may become caught Rating label About the Labels Affixed to the UnitModel name Confirmation of Included Items System ConfigurationFrame and Control Box Installation Installation and AssemblyFront Installing the Sensor and the Small Retainer Rail Slider InstallationTop View Power Cord Connection and Large Retainer Installation Installing the MirrorArm Installation Front RearOperation Panel Adjusting the Sensors PositionFor Both the CJ and the FJ Operating Conditions for the TUFor the CJ Only For the FJ OnlyMounting the Flange and Paper Tube Loading MaterialSide view of flange Correct Loading Rolled MaterialIncorrect Correct IncorrectPrinted surface is moved to the outer side and taken up Securing the Material in PlacePrinted surface is moved to the inner side and taken up Starting Operation Removing Material MaintenanceCJ doesnt run What to Do IfFJ doesnt run TU doesnt take up materialTU-60 TU-70 TU-400 TU-500 SpecificationsMemo R8-990901