Ramsey Electronics URC1 manual Charts and Diagrams, Qh’

Page 20

Charts and Diagrams:

Display Conventions:

		0		8
		1		9
		2		A
		3		B
		4		C
		5		D
		6		#
		7		*
Pinouts of CON2:
Pinouts of CON2:

	Pin #		Name		Description
	1		GND		Ground
	2		GND		Ground
	3		LDS	Load Shift Registers
	5		CLK		Serial Clock
	6		GND		Ground
	7		DATA		Serial Data
	8		GND		Ground
	9		LDP		Load Pots
	10		GND		Ground
	11		COUT	Pots Serial Out
	12		QH’	Shift Registers Out
	13		+5V		+5V
	14		+5V		+5V

Note: This jack is not used unless you plan on expanding your kit for more control pots and outputs.

URC1 • 20

Image 20

Contents Universal Remote Control Ramsey Transmitter Kits Table of Contents Ramsey ELECTRONICS, INCURC1 Remote Control Features Introduction to the Ramsey URC1HOW the URC1 Works Ramsey Learn AS YOU Build Assembly Strategy Tips and NotesRamsey URC1 Parts List Semiconductors CapacitorsResistors Hardware and MiscellaneousConstruction of the URC1 URC1 7805 Shiny side Topside PC Board Nut Screw URC1 Support wire Solder Fillet Main Displayboard URC1 Initial Testing Troubleshooting Tips Using Your URC1 URC1 URC1 Setting up the URC1 Charts and Diagrams QH’Common To access the URC1 To set the passwordURC1 Control Codes To set an output on or offTo set a Level To set a Control PotTo set a Timer To vary the resistance up*CLevel ## or *2Level ##Special codes Resetting the entire unit For the master user to exclude devices from the userOther tones Testing the URC1Done Accessing the URC1 URC # Connector considerations Expanding NotesURC-1 Parts Layout Diagram Ramsey Kit Warranty URC1 Universal Remote Control Estimated Assembly TimeRequired Tools Additional Suggested Items