From confirm out
From CON1 pin 33
Setting up the URC1:
These are some general ideas for setting up the URC1 for either a multiple user remote control, or a protected mode of operation. We will start from very first power up, all the way to leaving the URC1 to do it’s stuff. If you are interested in more details about the codes used refer to the the section on URC1 command codes.
1.Power up and test the URC1 as instructed in the initial testing section of the manual.
2.Hook up any of the peripherals that you may want to control such as lamps, radios, alarm systems etc. Make sure commons on circuits are connected properly to the URC1.
3.Enter in as a master user using *6. Use your tone generator to set the devices you want to exclude from the user, such as the alarm system. Use the control codes in the rear of the manual for instructions.
4.Set your initial values, check everything out for proper operation.
5.Set the user password, which is limited to three characters, and then the master password which is limited to four. Make sure and write these down. If you forget them, you have to disconnect the power and remove the battery to reset them.
6.Press *3 to tell the