InstallingtheBattery

See “Setting Up Your Phone” on page 2.

RemovingtheBattery

1.Make sure the power is off so that you don’t lose any stored numbers or messages.

2.To open, place fingernail inside the slot, apply slight pressure ( ), and slide cover down ( ).

3.Lift the battery up and remove it from the phone ( ).

WARNING Do not handle a damaged or leaking Li-Ion battery as you can be burned.

ChargingtheBattery

Keeping track of your battery’s charge is important. If your battery level becomes too low, your phone automatically turns off, and you will lose any information you were just working on.

Always use a Sprint-approved or Kyocera-approved desktop charger, travel charger, or vehicle power adapter to charge your battery.

1.Plug the phone charger into an electrical outlet.

2.Plug the other end of the phone charger into the micro-USB connector located on the upper left side of your phone.

With the Sprint-approved Li-Ion battery, you can recharge the battery before it becomes completely run down.

Phone Basics

2A. Phone Basics

15

Page 27
Image 27
Sony SCP3810 manual InstallingtheBattery, RemovingtheBattery, ChargingtheBattery, See Setting Up Your Phone on