Texas Instruments TVP5146EVM quick start Setting the PC Parallel Port Mode

SLEU063

c.Correct the problem.

d.Click OK to continue. The real-time polling dialog should appear. See Section 3.2.3.

Figure 20. Corrective Action Required

2.If the cable is connected from the PC parallel port to the TVP5160EVM AND the EVM power is on:

a.Click Yes.

b.The dialog shown in Figure 21 appears. This dialog appears if the PC parallel port mode setting may need to be changed.

NOTE: Only run the PC BIOS setup program if the I2C communication problem cannot be resolved in another way. (Correct slave address settings, reset or power cycle the EVM and/or check that the device type selected was TVP5160).

c.Click OK to continue.

d.The real-time polling dialog appears. Click OK to close it and get to the main menu.

e.Click Exit in the File menu to exit the program.

f.See troubleshooting guide above.

Figure 21. Corrective Action Required

9.2.1 Setting the PC Parallel Port Mode

NOTE: Only run the PC BIOS setup program if the I2C communication problem cannot be resolved in another way. (Correct slave address settings, reset or power cycle the EVM, and/or check that the device type selected was TVP5160).

TVP5160EVM User’s Guide 35