Winegard manual About Your SS-3000 Antenna, Installation, Attaching the clips to the Reflector

About Your SS-3000 Antenna

Thank you for choosing the low profile SS-3000 antenna. Winegard antennas are designed to deliver sharp, clear, high definition signal reception. At Winegard, our engineering department is dedicated to designing antennas that embrace both the latest technology and the aesthetics of any viewing environment. The SS-3000 installs in minutes; it’s easy to use and simple to adjust. Before installing your antenna, please remove all parts from the box, and read the manual carefully.

Antenna

Reflector

Antenna Base

(4) Clips

Collar Clamp

Installation

Attaching the clips to the Reflector

1.Lay the reflector flat on the table.

2.Grip the reflector with your thumb and index finger, and bend the reflector’s top and bottom edges towards you. (See Fig. 2, 3.)

3.With your other hand, grasp the clip, and attach it to the reflector at the two notches.

4.Repeat steps 2 and 3 for all four clips.

Fig. 2

Notch

6’ Mini Coax Downlead ANT.

An additional piece of RG6/U coax cable can be used to extend the cable length

from the antenna to the Power Injector up

to 50’. Use FS-8100 cable to cable connec- tor to combine cables.

Power IN

	6’ Standard
AC Adaptor	Coax Cable
	(Supplied)
(Supplied)

FRONT OF ANTENNA

POINT TOWARD

	SIGNAL
	Power
	Injector
	TV
	Coax Cable to Digital
	TV, Digital Converter
	Box, Distribution Amp
LED	or Splitter

Notch

Fig. 3

Installation

1.Find clamp collar half with two holes. Attach to antenna with the two long screws. Do not tighten at this time.

2 3