Winegard RD-4600, RD-4646 Installation & Assembly, Antenna closer than 10 from edge of roof

Page 2

INSTALLATION & ASSEMBLY

STEP 1. Choose a location for antenna that will allow it to rest in travel position with top of reflector pointing toward rear of vehicle and to raise and rotate without interfering with other roof-mounted equipment. Make sure inside ceiling area is clear where ceiling plate will mount.

NOTE: Figure 1 shows minimum distance (10") antenna should be located from edge of vehicle roof. We recommend you check with your dealer or the manufacturer to see what provisions have been made in the roof for antenna mounting. A reinforced area of roof as well as pre-wire downlead may be available.

NOTE: The system must be level for proper operation. If you have a curved roof you should use a Winegard Models RW-1000IW-1001 wedge kits to level the system.

STEP 2. Position template on roof (pg. 15 this manual) and drill a 1-3/4"hole through roof and ceiling of vehicle. Take care to avoid damage to wiring which may run between roof and ceiling.

STEP 3. The mount is designed to fit roofs 1" to

6 3/4" thick. Cut elevating shaft and directional handle to size, see table below.

CAUTION: IF YOU ARE USING THE RW-1000

ROOF WEDGE, ADD 1/2" TO ELEVATING SHAFT

LENGTH GIVEN BELOW, BUT NOT TO THE

DIRECTIONAL HANDLE.

Center

 

It is highly recomended that the antenna be

 

 

 

RoofLine

 

mounted on roof center line. Do not mount

 

antenna closer than 10" from edge of roof.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

19.50"

 

 

 

 

 

 

 

 

 

 

 

34" DIA.

 

 

 

 

 

OPERATING

 

 

 

 

 

 

 

 

 

 

AREA

 

 

 

 

 

26"

 

 

 

 

RW-1000

Roof Wedge

17" RADIUS

Vehicle Roof

Antenna Controls

IW-1001

Ceiling Wedge

 

Front of the RV

NOT TO SCALE

2

FIGURE 1

 

Image 2
Contents Installation Instructions Install Point Base Toward Front VehicleInstallation & Assembly Antenna closer than 10 from edge of roofAttach reflector to backup assembly as shown in Figure Inside RV Travel Position Approximately Degrees from Travel PositionDirectional Handle Point toOperation Elevation Turns CCWPosition Except Travel Position Tuning Antenna for Best PictureLowering Antenna to Travel Position Mount Lubrication MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Lubricating Rubber Quad RingOrdering Repair Parts Trouble ShootingWarranty Repair Work Parts List Rear ViewLnbf Interior Hardware KIT Specifications Antenna & MountANTENNA/LIFT/LNBF TWO Year Limited Warranty Roof Template Goes Here
Related manuals
Manual 16 pages 30.92 Kb

RD-4646, RD-4600 specifications

The Winegard RD-4646 and RD-4600 are advanced high-gain satellite antennas designed for consumers and mobile users who demand exceptional performance and reliability in a compact form factor. These antennas are engineered to provide a strong signal reception across a wide range of frequencies, making them suitable for various applications, including RVs, boats, and stationary installations.

The Winegard RD-4646 boasts a significant gain level, which allows it to capture signals from satellites located at greater distances. This is particularly advantageous for users in remote locations or areas with challenging terrain. The RD-4646 features a robust construction and a sleek design, ensuring durability while maintaining an elegant appearance. With its 360-degree reception capabilities, this model eliminates the need for manual adjustments and enhances user convenience.

On the other hand, the Winegard RD-4600 is engineered for versatility and ease of use. It features a compact design, making it suitable for smaller setups while still delivering solid signal performance. The RD-4600 is equipped with automatic satellite acquisition technology, allowing users to lock onto satellites with minimal effort. This feature is especially beneficial for mobile users who frequently change locations, as it drastically reduces setup time.

Both antennas come with a weather-resistant finish, protecting them from harsh environmental conditions, which is crucial for outdoor applications. The RD-4646 and RD-4600 employ advanced materials and innovative construction techniques, ensuring they can withstand extreme weather while maintaining signal integrity.

Another significant feature of the Winegard RD series is their compatibility with various satellite services, including Directv and Dish Network. This versatility ensures that users can choose the service provider that best fits their needs without worrying about compatibility issues.

In conclusion, the Winegard RD-4646 and RD-4600 are exceptional choices for satellite antenna systems. Their advanced technologies, robust features, and user-friendly designs make them suitable for a variety of applications, from mobile users to stationary setups. With their ability to receive strong signals in challenging environments, these antennas represent a solid investment for anyone seeking reliable satellite communication. Whether you are an RV enthusiast, a boater, or someone looking to enhance their satellite reception at home, the RD-4646 and RD-4600 will exceed your expectations.