Palsonic VCR9688 Channel Selection, Tuning with the V CH V Buttons, Selecting AUX Position

Page 15

CHANNEL SELECTION

Tuning with the V CH V Buttons

1.Press the OPERATE/TIMER button to turn on the VCR.

2. Press the buttons to select the position number to which the desired channel has been preset.

P10

.NotesIf the buttons are pressed and immediately

released, the preset position steps up or down and the

corresponding channel is tuned.

. If the

buttons are held in for longer than 0.5

second, the position numbers will keep changing until the button is released.

Tuning with the Number Buttons (Remote Control Only)

For channels preset in single-digit position

Press the 0 button, then the corresponding number button (1 to 9) within three seconds.

For channels preset in two-digit position

1.First enter the ten’s digit with one of the NUMBER buttons 1-9

2.Then enter the one’s digit within 3 seconds with the NUMBER buttons 1-9 and 0

.NotesIf you select a position with no assigned channel, it is

. not valid, and the previous channel will reappear.

If you wait more than 3 seconds to enter the second digit, the first digit will disappear and the previous

. position number will reappear.

Even when "SKIP" is set to "NC" on the CHANNEL PRESET Screen (see page 9) it is possible to select channels with the NUMBER Button.

Selecting AUX Position

The AUX (auxiliary input) position (displayed as "AU") may be selected with the 0/AUX button. When the AUX position is selected, recording from an external A/V

.source may be performed with the AUDIO/VIDEO socket. Press the 0/AUX button twice to select the AUX position.

E-11

Page 14 Page 16
Image 15
Page 14 Page 16
Contents VCR-9688 How to Use This Manual Remote control unit Front panel Rear panel Multi-display Identification of ControlsMulti-display Remote Control UnitFront Panel Rear PanelMaintain Good Ventilation Contents Introduction Equipment Connection InstallationConnection of VCR and TV Using Audio/Video Connector Power Supply CablePreparations To Execute AMS again after the Initial Setting Initial Setting UpChanging the Language after the Initial Settings Changing the Time after the Initial SettingOn Screen Display OSD Using the Menu ScreenUsing the Mode Screen Menu Screen/Mode ScreenAutomatic Channel Changing Channel PresettingManual Tuning AMS OperationPreperation for G-Code Instant Video Programming Selecting AUX Position Tuning with the V CH V ButtonsTuning with the Number Buttons Remote Control Only Channel SelectionDigital Tracking Control Auto Head CleanerPlayback Basic OperationFrame Advance Special Effect PlaybackSearch Still FrameMinute Skip Zero ReturnBlueback Function Recording Changing OTR Duration One-touch Timer Recording OTRCounter Function Counter DisplayProgrammable Timer Recording Programming procedureBefore programming Hints on Programming When two programmes overlapExtending the Recording Time Code Instant Video ProgrammingIf the G-Code number is incorrect About Error MessagesOthers Symptom Cause RemedySpecifications General Section Palsonic Customer Service Telephone
Top Page Image Contents