About Error Messages

5.Use the screen below to check the settings. If this is

the first time G-Code has been used for a channel,

use the buttons to enter the position number. Refer to the table on page 10 for details. This setting is only required the first time.

The POS settings can be changed. Use the < SHIFT > buttons to select the item and press the buttons to change the settings. To cancel the settings, press the RESET button.

G-CODE 1234567

DATE 31/12

START 20:00

STOP 23:45

POS

OK	= [G-CODE]
CANCEL = [RESET]
DATA	= [ VV ] SHIFT =[< >]

.NotesThe channel position programmed the first time the G- Code function is used, is automatically displayed from

. the second time.

If the POS setting is changed, the new setting is used until it is changed again.

6.Check that all the settings are as you wish then press the G-CODE button.

The Timer Program screen appears for few sec- onds. Then the VCR returns to the normal screen.

Notes

A program cannot be set while the POS indicator is

[ ]. Always use the buttons to select a position number.

This completes the procedure for G-Code program, Press the OPERATE/TIMER button for 3 seconds, or longer, to enter Timer Stanby mode.

To cancel this mode, hold the OPERATE/TIMER button down for three seconds again.

. If the G-Code number is incorrect

"ERROR" and the G-Code number blink. Then cor- rect a G-Code number follow fhe procedure for "Cor- recting a number" on the previous page.

. If the G-Code number and the recording mode do not match. For example, a program on a Saturday or Sunday is scheduled for DAILY (MO-FR) re- cording.

"ERROR" and "DAILY" blink and the recording mode is forcibly set to ONCE.

G-CODE 1234567

ONCE DAILY WEEKLY

ERROR

E-20